Abstract:The electromagnetic interference (EMI) filter is essential for industrial products to comply with EMI standards. It can reduce the EMI noise, which may cause harmful effects on other electronic devices or human health. However, the EMI filter typically occupies a large volume, around one-third of the entire power supply volume, leading to a deterioration in power density. Among previous studies, the winding cancellation method is an attractive approach for reducing the volume of EMI filter. It can reduce the common-mode (CM) noise by canceling the CM voltages of the transformer without requiring shielding layers. However, the winding cancellation method is only applicable to specific topologies. Particularly, in topologies with an output inductor, the implementation of winding cancellation method requires additional components such as reset windings or capacitors. Therefore, this article proposes a novel coupled inductor rectifier that enables the winding cancellation method without any additional components. The proposed rectifier ensures that the voltages generated at the primary and secondary nodes of the transformer have the same dv/dt directions. Consequently, the CM voltages of the transformer cancel each other, leading to the significant mitigation of CM noise. Furthermore, the proposed rectifier can be implemented simply by replacing the existing output inductor with a coupled inductor. It does not require additional components and has the same circuit characteristics as conventional converters. Finally, the proposed rectifier can be extended to different converter topologies with an output inductor. As a result, the proposed rectifier can achieve high power density by reducing the volume of EMI filter. To verify the performance of the proposed rectifier, laboratory prototypes of forward and asymmetric half-bridge converters were built and tested. The proposed prototypes reduced CM noise by 9.7 and 15.4 dB, respectively, compared to conventional prototypes through winding cancellation. Consequently, the volume of EMI filter in the proposed prototypes was reduced by 55.7% and 75.9%, respectively.

Implementation of a novel active common-mode filter used in DC-DC converters

A Novel Common-Mode Conducted EMI Filter for Boost PFC Converter

A Symmetrical Resonant Converter and PCB Transformer Structure for Common Mode Noise Reduction

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

Design of Input Filter for DC/DC Converter

An Experimental Study Of Common- And Differential-Mode Active Emi Filter Compensation Characteristics

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

A novel and simple approach to suppress common-mode EMI in power converters

Modeling And Measurement Of A Common-Mode Filter Based On The 3-D Transmission Line Structure

EMI Filter Design Based on High-Frequency Modeling of Common-mode Chokes

Design and Experiment Research of Integrated EMI Filter Based on Flexible Multi-Layer Foils

PFC converter with novel integration of both EMI filter and Boost inductors

Common-Mode Noise Suppression in Isolated DC-DC Converters Based on Coupled Inductor Rectifier

An Improved Foster Model of Common-Mode Inductor and Its Application in EMI Filter Design

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

Notice of Retraction: A Novel Coplanar Common-Mode Filter with a Wide Stopband

An Alternating High‐low Impedance Common‐mode Filter for Differential Striplines

Design of active EMI filter based on virtual impedance transform method

Digital Active EMI Filter for Smart Electronic Power Converters

An Integrating Structure of EMI Filter Based on Interleaved Flexible Multi-Layer (FML) Foils

Suppressing Methods of Common-Mode Noise in LLC Resonant DC-DC Converters