Abstract:The high voltage bushing on the grid side of UHV converter transformer is located at the connection position between the grid side winding of converter transformer and the AC side system, which is the key equipment of UHVDC transmission system. In actual operation, the bushing will bear high temperature, large load current and additional load for a long time. In addition, due to the limitation of process level. During the rolling process of bushing capacitor core, there are inevitably some defects such as plate wrinkle, plate offset and unreliable grounding of the end plate. Under the long-term action of electricity, heat and stress, small defects are likely to develop into larger defects or even cause faults. Therefore, it is of great significance to study the influence of different defects on the electric field distribution in the bushing core and the partial discharge initial voltage (PDIV) of the bushing. On the basis of 550kV capacitive bushing, this paper designed and manufactured four scaled models. The rated working voltage of scaled models are 31.8kV. And the corresponding finite element simulation models are also established. The simulation results show that the wrinkle defect and offset defect will cause serious electric field distortion, resulting in a sharp increase of electric field at the defect. Ungrounded defects will completely change the distribution of electric field in the bushing, making the electric field concentrated in the insulating oil between the flange and the end plate. The measurement of PDIV shows that the wrinkle defect and offset defect can significantly reduce the PDIV which makes the bushing prone to PD at a lower voltage level and lead to fault. The initial voltage drop of ungrounded partial discharge is less, but the discharge amount is large. Therefore, the research of this paper has guiding significance for timely finding the original defects of bushing, preventing the development of defects, and solving the problem of frequent failure of converter bushing.

Analysis on Failure causes of bushing used in 40.5kV metal enclosed air insulation switchgear

Overview on gas discharge occurring in air insulated metal enclosed switchgear

Research on insulation state evaluation and detection technology for 40.5 kV switchgear wall bushing

Application condition of 40.5kV air insulated metal enclosed switchgear with VCB in China

Optimization Design of Bushing of Distribution Switchgear Equipment

Influence of Defects on the Electric Field Distribution of ±800kV Butt-type DC Wall Bushing

Research on Insulation Aging of Distribution Switchgear

Simulation of High Voltage Porcelain Bushing under Complicated Working Conditions

Investigation of the Role of Void Sizes for Failure of High Voltage Bushing

Research on the Overheating Fault of HVDC Wall Bushing and Its Dignosis Strategies Based on CFD

Simulation analysis and calculation of electric field distribution characteristics of UHV wall bushing

Defect Diagnosis Of Hvdc Bushings Based On Sf6 Decomposition And Partial Discharge Characteristics

Analysis and Disposal of Typical Breakdown Failure for Resin Impregnated Paper Bushing in the Valve Side of HVDC Converter Transformer

Electric field calculation and shield optimization for 1000kV GIS bushing

Research on Insulation Configuration of 220 kV Bushing in High-Altitude Polluted Areas

Analysis on Breakdown Failure in Basin-type Insulator of 1 100 kV GIS

Influence Analysis on Defects in Bushing Core at Grid Side of Converter Transformer

Insulation Degradation of Epoxy Resin Impregnated Paper Bushing under Discharge Arc Ablation

Investigation of Failure of High Voltage Bushing at Power Transformer

Location and Analysis of Inner Breakdown Failure in GIS Supporting Insulator

Bushing PD Analysis and Electric Field Simulation