Simulation Study on Pulse-Modulated RF-Driven Atmospheric Pressure Argon Dielectric Barrier Discharge
Bing Qi,Xiao Tian,Tao Zhang,Yishan Wang,Jinhai Si,Jie Tang
DOI: https://doi.org/10.1109/tps.2024.3419574
IF: 1.368
2024-01-01
IEEE Transactions on Plasma Science
Abstract:The characteristics of pulse-modulated RF-driven atmospheric pressure argon (Ar) dielectric barrier discharge (DBD) have been investigated, on the basis of a 1-D coupled fluid model. Time-domain variations of the voltage and the charge density on the dielectric surface ( V-k and sigma) were obtained for different radio frequency (RF) voltage amplitudes ( V-RF) . Furthermore, the minimum voltage amplitudes of RF maintenance discharge ( V-RFmin) changing with the pulse duty cycle (D-R) and pulse modulated frequency ( f(RF,p)) were discussed, and the variation of spatiotemporal average electron density with spatiotemporal average sheath voltage during the low-frequency period was studied for various D-R and f(RF,p) . It was found that V-k and sigma cannot reach a periodic steady state for smaller V-RF . When V-RF is 600 V, it is shortened to 2.36x10(-6)s (about 32 RF periods), comparing with that when V-RF is 280 V. V-RF,V-min decreases as D-R increasing from 20% to 100%.The discharge is only in gamma mode for smaller DR while it exists in alpha and gamma modes for greater D-R. In addition, V-RF,V-min increases along with f(RF,p) growing from 0.01937 to 0.1356 MHz. When f(RF,p) is higher, the gamma mode exists for discharge, while when it is lower, there are two modes:alpha and gamma.