Abstract:To increase the power rating and improve the reliability of the single-phase power supply system, the input-parallel output-parallel (IPOP) single-phase dc/ac converters (SDACs) are widely used. However, among the IPOP SDACs, there are complicated circulating currents which will increase the current stress on the switching devices and influence the safe operation of the system. But, the detailed quantitative analysis of the circulating currents is not well developed and the corresponding suppression strategies are not very comprehensive. Focusing on these problems, this paper pays attention to the detailed mathematic model and effective suppression strategy of circulating currents among IPOP SDACs. First, the detailed mathematic model of the circulating currents is established. Based on this model, it is found that there are various types of circulating currents existing in the IPOP SDACs, including circulating currents within the single SDAC and circulating currents among the multiple SDACs. At the same time, the influence factors are also analyzed, and it is first revealed that the asymmetry of impedances in different sides will cause circulating currents with different frequencies components including the dc, fundamental, and second frequencies. Second, after the detailed analysis, a decentralized control method composed of the common mode (CM) and differential mode (DM) control is proposed to suppress the complicated circulating currents. The control method is comprehensive and can suppress circulating currents caused by diverse influence factors. All the theoretical analyses are verified by the real-time hardware-in-loop (HIL) tests.

Analysis and Suppression Strategy for the Double-Line Frequency Pulsation in Single-Phase Quasi-Z-Source Converter

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

Design and Analysis of Single-Stage Power Factor Correction Converter with a Feedback Winding

Decentralized Suppression Strategy of Circulating Currents among IPOP Single-Phase DC/AC Converters

Analysis and Suppression of Common-Mode EMI Noise in 1 MHz 380 V-12 V DCX Converter with Low NFoM Devices

Performance Analysis of Asynchronous PWM at Low Carrier Ratios

Analysis of Flux Density Bias and Digital Suppression Strategy for Single-Stage Power Factor Corrector Converter

An Improved Quantitative Analysis Method of Oscillation Mode for DFIG-Based Wind Power Base with LCC-HVDC Transmission Considering Frequency Coupling Characteristic

Loss Distribution Analysis of Three-Level Active Neutral-Point-Clamped (3L-Anpc) Converter with Different Pwm Strategies

Suppressing Method of Common-Mode Noise in MHz 380V-12V DCX Converter

Second Harmonic Current Reduction of Dual Active Bridge Converter under Dual-Phase-shift Control in Two-Stage Single-Phase Inverter for Residential Energy Storage System

A Multiplexing Modulation Strategy Based On Single-Phase Ac/Dc Converter With Optimized E-Capless Function

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Design and Loss Analysis of the High Frequency Pfc Converter

Suppression Strategy of Differential Mode Circulating Current in Parallel Three-Phase PWM Converter

Low Frequency Current Ripple Suppression for Two-Stage Single-Phase Inverter Based on Impedance Editing

An Active Filter Method to Eliminate DC-Side Low-Frequency Power for Single-Phase Quasi-Z Source Inverter

Optimized MMC passive impedance shaping method for high frequency oscillation suppression

Analysis and Optimization of High-Frequency Switching Oscillation Conducted CM Current Considering Parasitic Parameters Based on a Half-Bridge Power Module

Impedance design of quasi-Z source network to limit double fundamental frequency voltage and current ripples in single-phase quasi-Z source inverter

Overview of Double-Line-Frequency Power Decoupling Techniques for Single-Phase Z-Source/Quasi-Z-Source Inverter