Abstract:This article presents a 39 GHz transceiver front-end chipset for 5G multi-input multi-output (MIMO) applications. Each chip includes two variable-gain frequency-conversion channels and can support two simultaneous independent beams, and the chips also integrate a local-oscillator chain and digital module for multi-chip extension and gain-state control. To improve the radio-frequency performance, several circuit-level improvement techniques are proposed for the key building blocks in the front-end system. Furthermore, an advanced low-temperature co-fired ceramic process is developed to package the 39 GHz dual-channel transceiver chipset, and it achieves low packaging loss and high isolation between the two transmitting (TX)/receiving (RX) channels. Both the chip-level and system-in-package (SIP)-level measurements are conducted to demonstrate the performance of the transceiver chipset. The measurement characteristics show that the TX SIP provides 11 dB maximum gain and 10 dBm saturated output power, while the RX SIP achieves 52 dB maximum gain, 5.4 dB noise figure, and 7.2 dBm output 1 dB compression point. Single-channel communication link testing of the transceiver exhibits an error vector magnitude (EVM) of 3.72% and a spectral efficiency of 3.25 bit·s−1·Hz−1 for 64-quadrature amplitude modulation (QAM) modulation and an EVM of 3.76% and spectral efficiency of 3.9 bit·s−1·Hz−1 for 256-QAM modulation over a 1 m distance. Based on the chipset, a 39 GHz multi-beam prototype is also developed to perform the MIMO operation for 5G millimetre wave applications. The over-the-air communication link for one- and two-stream transmission indicates that the multi-beam prototype can cover a 5–150 m distance with comparable throughput.

A tri-band, 2-RX MIMO, 1-TX TD-LTE CMOS transceiver.

A Power-Area-Efficient, 3-Band, 2-Rx Mimo, Td-Lte Receiver With Direct-Coupled Adc

A 39 GHz Dual-Channel Transceiver Chipset with an Advanced LTCC Package for 5G Multi-Beam MIMO Systems

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

D-band CMOS Transmitter and Receiver for Multi-Giga-bit/sec Wireless Data Link

A compact dual-band direct-conversion CMOS transceiver for 802.11a/b/g WLAN

9.1 A 45nm CMOS RF-to-Bits LTE/WCDMA FDD/TDD 2×2 MIMO base-station transceiver SoC with 200MHz RF bandwidth

A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 Nm CMOS.

A D-Band Joint Radar-Communication CMOS Transceiver

A Highly Reconfigurable 65nm Cmos Rf-To-Bits Transceiver For Full-Band Multicarrier Tdd/Fdd 2g/3g/4g/5g Macro Basestations

A High-Linearity WCDMA/GSM Reconfigurable Transceiver in 0.13- CMOS

A 2×2 MIMO multi-band RF transceiver and power amplifier for compact LTE small cell base station

A 0.1 Similar To 4ghz Receiver And 0.1 Similar To 6ghz Transmitter With Reconfigurable 10 Similar To 100mhz Signal Bandwidth In 65nm Cmos

An Ultra-compact Bidirectional T/R Folded 25.8-39.2GHz Phased-Array Transceiver Front-End with Embedded TX Power Detection/Self-calibration Path Supporting 64-/256-/512-QAM at 28-/39-GHz band for 5G in 65nm CMOS Technology

A Monolithic Dual-Band 77/94 GHz Transceiver Front-End with Shared Frequency Multiplier

A 0.1∼4GHz receiver and 0.1∼6GHz transmitter with reconfigurable 10∼100MHz signal bandwidth in 65nm CMOS

A fully-integrated reconfigurable dual-band transceiver for short range wireless communication in 180nm CMOS

A 130nm CMOS direct conversion transmitter for WCDMA

An Energy-Efficient 10-Gb/s CMOS Millimeter-Wave Transceiver with Direct-Modulation Digital Transmitter and I/Q Phase-Coupled Frequency Synthesizer

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A Fully Integrated QPSK/16-QAM D-Band CMOS Transceiver With Mixed-Signal Baseband Circuitry Realizing Digital Interfaces