Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A resistive-feedback LNA in 65 nm CMOS with a gate inductor for bandwidth extension.

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

The Design of Broadband LNA with Active Biasing Based on Negative Technique

Design of broadband LNA with active biasing using negative feedback technique

A 28 GHz LNA using defected ground structure for 5G application

Analysis And Design Of Inductorless Wideband Low-Noise Amplifier With Noise Cancellation Technique

A Gm-boosted and current peaking wideband merged LNA and mixer

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

Design of a Broadband Ka-band MMIC LNA Using Deep Negative Feedback Loop.

A1V 6mW inductorless wideband LNA in 0.13μm RF CMOS

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A 0.03-3Ghz Inductorless Wideband Low Noise Amplifier in 65nm CMOS

A CMOS 0.5&#x2013;10.6 GHz Inductor Feedback Low Noise Amplifier for Multi-Standard Application

A dual band CMOS two-stage variable gain low noise amplifier

A wideband inductorless LNA exploiting three-stage feedback and thermal noise canceling

A High-Linearity Wideband Common-Gate LNA with a Differential Active Inductor.

A Low Power Inductorless Wideband LNA With G m Enhancement and Noise Cancellation