Abstract:Regenerative chatter can reduce machining quality, tool life, and productivity during milling process. In order to control the milling chatter, the stability analysis of milling system is very important. It has been found that variable spindle speed milling and the use of variable-angle tools are effective to control milling chatter. This paper mainly studies the control effect when these two methods are used simultaneously. Firstly, the improved full-discretization method is used to predict the stability of variable spindle speed milling process with variable pitch cutters. And on the basis of stability prediction, the influence of spindle speed modulation parameters on stability is analyzed. Meanwhile, the stability prediction results of down-milling and up-milling operations, different radial immersion ratio and different tooth pitch variation form are compared. The results show that the stability of variable spindle speed milling process with variable pitch cutters is better than that of variable pitch cutters in constant spindle speed milling process. And the improvement of the stability is related to the spindle speed modulation parameters. When the modulation parameters are bigger, the stable cutting area of the stability lobes diagram will be larger. Secondly, in the up-milling operation and the low immersion operation, the variable spindle milling with variable pitch cutters has better stability than the down milling operation and the high immersion operation. Under the condition that the pitch angles vary linearly, the stability is better. Finally, the time domain simulation is performed and the simulation results verify the accuracy of the stability prediction results.

Stability Analysis and Stabilization of a Class of Cutting Systems with Chatter Suppression

Discrete Time-Delay Optimal Control Method for Experimental Active Chatter Suppression and Its Closed-Loop Stability Analysis

Stability and Control for Cutting Chatter Based on Active Magnetic Bearings

Stability analysis for milling system with variable pitch cutters under variable speed

Stability Analysis and Test for Cutting Chatter of a Slender Shaft

Numerical Integration Method for Stability Analysis of Milling With Variable Spindle Speeds

Chatter suppression analysis for variable pitch cutter in milling

Stability Analysis Of A Variable Spindle Speed Milling Process

Stability analysis for variable spindle speed milling via the 3rd-order Newton-Cotes method

Online Chatter Suppression in Turning by Adaptive Amplitude Modulation of Spindle Speed Variation

Modeling, Analysis, and Removal of Chatter Marks in Flexible Turning

Efficiency Analysis of Sinusoidal Stiffness Variation Method for Chatter Suppression

Active Control of Milling Chatter Considering the Coupling Effect of Spindle-Tool and Workpiece Systems

Stability of Up-milling and Down-milling Operations with Variable Spindle Speed

Estimation and Improvement of Cutting Safety

Stability Prediction of Milling with Periodic Spindle Speed Modulation based on Global Discrete Algorithm

Stability analysis of milling chatter in six-degree-of-freedom industrial robots

Active chatter control in high speed milling processes based on H∞ almost disturbance decoupling problem

Stability analysis of machine tool spindle under uncertainty

Model-Free Adaptive Sliding Mode Control-Based Active Chatter Suppression by Spindle Speed Variation

Stability Analysis for Milling Operations Using an Adams-Simpson-based Method