Abstract:Over the past years, we have exploited the bistability features that are commonly found in many individual sensors to develop a network-based [Acebrón et al., 2003; Bulsara et al., 2004; In et al., 2003a; In et al., 2003b; In et al., 2005; In et al., 2006; In et al., 2012; Palacios et al., 2005] approach to modeling, designing, and fabricating extremely sensitive magnetic- and electric-field sensors capable of resolving field changes as low as 150[Formula: see text]pT and 100[Formula: see text]fAmps, respectively. Higher sensitivity is achieved by exploiting the symmetry of the network to create infinite-period bifurcations that render the ensuing oscillations highly sensitive to symmetry-breaking effects from external signals. In this paper, we study the effects of noise on the response of a network-based electric-field sensor as well as the effects of parameter mismatch, which appear naturally due to material imperfections and noise. The results show that Signal-to-Noise Ratio (SNR) increases sharply near the onset of the infinite-period bifurcation, and they increase further as the coupling strength in the network increases while passing the threshold that leads to oscillatory behavior. Overall, the SNR indicates that the negative effects of highly contaminated signals are well-mitigated by the sensitivity response of the system. In addition, computer simulations show the network-based system to be robust enough to mismatches in system parameters, while the deviations from the nominal parameter values form regions where the oscillations persist. Noise has a smoothing effect over the boundaries of these regions.

Figures-of-Merit to Evaluate the Significance of Switching Noise in Analog Circuits

Methodology to Determine Dominant Noise Source in a System-on-chip Based Implantable Device

Miller Effect Analysis and Noise Optimization of CMOS Low Noise Amplifier

Methodology For Modeling Simultaneous Switching Noise In Bga Packaging

Modeling of the Simultaneous Switching Noise in High Speed Electronic Circuit with the Integral Equation Method and Vector Fitting Method

Critical analysis on efficiency and noise reduction methodologies of a switch mode power supply using LISN topology

Modeling the simultaneous switching noise with the integral equation method and vector fitting method

Resistive Switching Assisted by Noise

Comprehensive Design Considerations and Noise Modeling of Preamplifier for MEMS Electrometry.

GaN Transistors' Radiated Switching Noise Source Evidenced by Hall Sensor Experiments Toward Integration

Noise Model of Relaxation Oscillators Due to Feedback Regeneration Based on Physical Phase Change

An Accurate Two-Port De-Embedding Technique for RF/Millimeter-Wave Noise Characterization and Modeling of Deep Submicrometer Transistors

Switching Noise Analysis for Conducted Electromagnetic Interference from of Power Electronic Module

Gate-Driving Performance Evaluation Based on a New Figure of Merit

Analysis Of Trade-Off Between Noise And Wide Band-Gap (Wbg) Device Switching Speed

Phase-Noise and Amplitude-Noise Measurement of DACs and DDSs

Measurement and Analysis of Current Noise in Chopper Amplifiers.

Experimental study on MOSFET's flicker noise under switching conditions and modelling in RF applications

Noise Analysis of A Low Noise Charge Sensitive Preamplifier

Noise and Parameter Mismatch in a Ring Network for Sensing Extremely Low Electric Fields