Abstract:A highly sensitive liquid refractive index (RI) sensor with a single-mode fiber-multimode fiber-tapered thin-core fiber-single-mode fiber (SMTTS) structure can be simulated and the method is the beam propagation method (BPM). The modal perturbation between core and cladding mode happened because of modal mismatch and the transmission spectrum is calculated by BPM. Liquid RI and spectral dip wavelength shift for demodulating RI values is obtained and their relationship is approximately linear. To make a comparison, transmissions of single mode fiber-thin-core fiber-single mode fiber (STS) as well as single mode fiber-multimode fiber-thin-core fiber-single mode fiber (SMTS) are also calculated. It is significantly shown that the interference is improved by the segment of multimode fiber (MMF). And the tapered thin-core fiber (TCF) has the functions not only further enhance the fringe visibility, but also increase the RI sensitivity, which is higher with the thinner thin-core taper diameter. The average RI sensitivity would reach up to −116.7nm/RIU within the RI range of 1.33 to 1.39 if the taper diameter is $53.5\ \mu\mathrm{m}$ . This is much higher than the value of SMTS structure. And in the practice application, it could be a slimmer taper in the SMTTS structure to improve the sensitivity just achieving by a simple fabrication process. All process could be finished using fusion splicer, cutter and hydrogen flame.

Numerical and Experimental Analysis of Sensitivity-Enhanced RI Sensor Based on Ex-TFG in Thin Cladding Fiber

Highly Sensitive Refractive Index Sensor Based on a Cladding-Etched Thin-Core Fiber Sandwiched Between Two Single-Mode Fibers

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

High Sensitivity Refractive Index Sensor Based on Large-Angle Tilted Fiber Grating with Carbon Nanotube Deposition

Refractive Index and Temperature Sensitivity Characterization of Excessively Tilted Fiber Grating.

Sectional Sensitivity in RI Sensor During Mode Transition with Regenerative Cladding Layer

Hybrid Grating in Reduced-Diameter Fiber for Temperature-Calibrated High-Sensitivity Refractive Index Sensing

High sensitivity refractive index sensor based on tilted fiber Bragg gratings

Enhanced Refractive Index Sensor Using a Combination of a Long Period Fiber Grating and a Small Core Singlemode Fiber Structure

Cladding Etched Strongly Coupled Seven-Core Fiber Modal Interferometer for Highly Sensitive Refractive Index Sensing

Refractive index and temperature-sensing characteristics of a cladding-etched thin core fiber interferometer

Study on spectral and refractive index sensing characteristics of etched excessively tilted fiber gratings

High Sensitivity Refractive Index Sensor Based On Tapered Thin-Core Fiber

High Sensitive Refractive Index Sensor Based on Cladding Etched Photonic Crystal Fiber Mach-Zehnder Interferometer

High Sensitivity Refractometer Based on Tapering Two-Mode Fiber Embedded Long-Period Fiber Grating

Enhanced sensitivity refractive index sensor using tilted fiber Bragg grating with thinned cladding

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

Enhanced Ri Sensor Using A Combination Of A Long Period Fiber Grating And A Small Core Singlemode Fiber (Scsmf) Structure

Improved optical fiber Mach-Zehnder high-sensitivity refractive index sensor

Sensitivity-controllable Refractive Index Sensor Based on Reflective Θ-Shaped Microfiber Resonator Cooperated with Vernier Effect.

Theoretical Analysis of an In-line Thin-core Fiber Based Refractometer