Abstract:Based on a high-speed spark ignition (SI) gasoline engine with five valves, a novel concept of asynchronous valves timing (AVT) and synchronous valves timing (SVT) systems has been proposed. In order to demonstrate the effect of AVT and SVT on gas exchange process, combustion process, engine performance, fuel economy and emissions, a comparative study between AVT and SVT systems are conducted by using computational fluid dynamics (CFD) simulation and experiment. Considering the disadvantages of original cam profile, the intake and exhaust cam profile are redesigned. The valve train would be able to work more steadily and reliably under the high speed movement condition after optimized. Followed experiments for the AVT and SVT schemes were performed under full load to measure engine performance and operating parameters. Finally, in order to study the in-cylinder working process, a numerical calculation was conducted by using the CFD code AVL-FIRE. Additionally, a GT-Power simulation model was set up and calibrated by experimental data to study the impact of AVT and SVT on gas exchange process and secure accurate boundary conditions for the CFD calculation. The simulation results show that AVT scheme can strengthen in-cylinder gas rotational flow, increase gas turbulence kinetic energy (TKE) at the ignition timing, which is beneficial to increase the flame propagation speed. The IVC timing can significantly affect the in-cylinder pressure and heat release rate. With late IVC, both the mass flow rate and the peak in-cylinder pressure of retarding 20 degrees CA opening are decreased. The experimental results show that the engine torque, BSFC, CO and HC emissions of advancing 20 degrees CA opening are better than those under retarding 20 degrees CA opening and SVT at full load. However, NOx and CO2 emissions are worse than those of the other two schemes. (C) 2016 Elsevier Ltd. All rights reserved.

Application of Adaptive Generalized S-transformation in Vibration Characteristics Analysis of an IC Engine Cylinder Head

Application of the AGST Method to the Vibration Analysis of the Diesel Engine Cylinder Head Cover

A General Approach to Tune the Vibration Properties of the Mounting System in the High-Speed and Heavy-Duty Engine

Study on Vibration Characteristics of Internal Combustion Engine Cylinder Head Based on S Transform

Comparison of Three Time-Frequency Analysis Techniques for Engine Cylinder Head Vibration Signals under Stable Conditions

Comparison of Different Techniques for Time-Frequency Analysis of Internal Combustion Engine Vibration Signals

Application of Acoustic Transfer Vector Algorithm on Acoustic Radiation for Drive Axle of Automobile

Analysis of Bearing Vibration Characteristics Using Hilbert-Huang Transformation

Analysis of Engine Vibration and Design of an Applicable Diagnosing Approach

A New Improved Synchrosqueezing Transform Based on Adaptive Short Time Fourier Transform

Virtual design of rigidity for valve train system in internal combustion engine

Effect of Asynchronous Valve Timing on Combustion Characteristic and Performance of A High Speed Si Marine Engine with Five Valves

Simulation and Analysis of Variable Valve Timing Technology in SI Engine

Time-frequency Post-Processing Method Based on Generalized S-transform and Its Application to Aero Engine Rotor System Fault Diagnosis

Application of EEMD and GST Method in Noise Characteristics Analysis of Internal Combustion Engine

A new technique based on traditional wavelet transform used in NVH application of internal combustion engine

Generalized S-Synchroextracting Transform for Fault Diagnosis in Rolling Bearing

Time-frequency Characteristics of Noise Signals Based on S Transform for Internat Combustion Engine

Valve Vibration Induced Intake Air Flow Dynamics Analysis Using Near Valve Particle Image Velocimetry

Generalized Horizontal Synchrosqueezing Transform: Algorithm and Applications

Study on the Time-Frequency Characteristics of Engine Induction Noise in Acceleration Based on S Transform