Abstract:Vibration signal monitoring and fault diagnosis are highly important and are of great significance for the stable operation of aeroengine rotor systems. However, the working conditions of aeroengine are complex, and its corresponding vibration during speed change often has obvious time-varying characteristics and contains a large amount of aerodynamic and combustion noise; therefore, the diagnosis of aeroengines is challenging. The conventional synchrosqueezing transform (SST) methods have several disadvantages for the processing of strong time-varying signals with low signal-to-noise ratios (SNRs). To solve this problem, this article proposes two kinds of time-frequency postprocessing methods based on the generalized S-transform (GST), namely, multisynchrosqueezing transform based on GST (GST-MSST) and second-order synchroextracting transform based on GST (GST-SET2). GST-MSST is less computationally burdensome but is not suitable for dealing with emphasized frequency modulation (FM) signals and can be applied to on-board online analysis; GST-SET2 is more computationally burdensome but is suitable for the analysis of strong FM signals and can be applied to offline fine analysis. The results of numerical simulation show that these two methods can provide clear and accurate time-frequency representation (TFR) with good noise robustness. Finally, a certain type of aeroengine pressurizer is taken as an example to verify the effectiveness of the method of this article in pressurizer fault diagnosis.

Study on the Time-Frequency Characteristics of Engine Induction Noise in Acceleration Based on S Transform

Study on the Time-Frequency Characteristics of Engine Induction Noise during Accelerating Period Based on S Transform

Time-frequency Characteristics of Noise Signals Based on S Transform for Internat Combustion Engine

Detection of inter-harmonics in power system based on s-transform

An impact feature extracting method based on S-transformation spectrum threshold denoising

Study on Vibration Characteristics of Internal Combustion Engine Cylinder Head Based on S Transform

Study on the Time-Frequency Characteristics of Engine Noise Signal Based on EMD and HHT

Identification of IC Engine Noise Source Based on Continuous Wavelet Transform of Vibration Signal

Comparison of Different Techniques for Time-Frequency Analysis of Internal Combustion Engine Vibration Signals

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

Application of Order Analysis in Intake Noise Research of Engine

Study of Time-Frequency Order Tracking of Vibration Signals in Engine Speed Changing Stage

A new technique based on traditional wavelet transform used in NVH application of internal combustion engine

Time-frequency Post-Processing Method Based on Generalized S-transform and Its Application to Aero Engine Rotor System Fault Diagnosis

Imaging of automotive engine components noise from non-synchronous sequential measurements

Research on the Online Measurement of Automobile Engine Speed Based on Vibration Analysis

Noise source identification of internal combustion engine using sound mode technology

Comparison of Three Time-Frequency Analysis Techniques for Engine Cylinder Head Vibration Signals under Stable Conditions

Time–Frequency Postprocessing Method Based on Generalized S-Transform and Its Application to Aeroengine Rotor System Fault Diagnosis

Internal Combustion Engine Noise Analysis with Time-Frequency Distribution

Noise Characteristics Analysis of Aero-Engine Testing Signals