Abstract:Current dual-constellation GNSS navigation receiver can not fully satisfies the development of navigation industry. The architecture of current Compass and GPS dual-constellation navigation receiver is usually built upon FPGA and float-point DSP. Compared with fix-point DSP and FPGA, float-point DSP works slow and costs much, and it is also difficult to integrate float-point DSP into ASIC or ASSP. So in this paper, we discuss the optimized algorithm and the new implementation that integrate all parts of navigation receiver on one FPGA or ASIC.Our revised algorithm of navigation receiver is introduced first, mainly including acquisition and tracking mechanism. For acquisition module, we divide the whole acquisition process into three units: noise threshold detection, pre-acquisition, acquisition verification. For tracking module, with the help of accurate fix-point simulation, float-point variables are converted to fix-point ones, and rescaling is applied during all process to assure precision.Algorithm only makes sense when it combines with implementation, and the quality of algorithm also should be tested by application. So we also introduce the implementation of navigation receiver baseband algorithm on FPGA platform, including platform architecture, module division, work flow, and some optimization mechanics including resource sharing, process combination and etc. And we simply introduce the measure result and the application of dual-constellation navigation receiver baseband processor.And viterbi decoder for navigation receiver is also discussed. This paper brings forward a revised mechanism of viterbi decoder especially for navigation receiver. We borrow the soft output viterbi algorithm, but do not adopt the algebra ring method, and put forward revised viterbi mechanics. And the optimization is also on shorten-decoding, survival-path combination, butterfly calculation of ACS unit.

Design Optimization and Implementation of Carrier Tracking Loop for High Sensitivity GPS Receivers

Design and Implementation of Micro-Satellite Receiver Using CORDIC Algorithm

Design of variable loop bandwidth high sensitivity micro-satellite receiver

Simulation and Optimization of Nested PLL in TT&C Transponder

A high-sensitivity GPS receiver carrier-tracking loop design for high-dynamic applications

An Improved Phase Lock Loop for Micromechanical Gyroscope with A Carrier Modulation

A 90-98-ghz FMCW Radar Transceiver Supporting Broadband Modulation in 65nm CMOS

Design of GPS base-band processing platform based on FPGA and ARM

Tracking Loops Design and Bandwidth Optimization for SINS-aided GPS Receiver.

Analysis Of Sins/Gps Tightly-Coupled Receiver Carrier Tracking Loop

Development and Evaluation of GPS L2C Software Receiver Baseband Signal Processing Module

ADS optimization design of GPS RF front-end circuit with auto gain control

A High Accuracy Time Keeping Scheme Based on GPS

Design and implementation of an optimized FIR filter for IF GPS signal simulator

Algorithm Design and Simulation Test for Software GNSS Receiver

Design and Realization of GPS RF Signal Source

Analysis and Design of a High-Linearity Receiver RF Front-End with an Improved 25%-Duty-cycle LO Generator for WCDMA/GSM Applications

Tracking Loop Design and Simulation for Digital DSSS Receivers

A High Dynamic Velocity Locked Loop for the Carrier Tracking of a Wide-Band Hybrid Direct Sequence/Frequency Hopping Spread-Spectrum Signal

Dual Update-Rate Carrier Tracking Technique for New Generation Global Navigation Satellite System Signals in Dynamic Environments

The Optimization of Algorithm and Implementation for Dual-Constellation Navigation Receiver