Abstract:As the construction and modernization of global navigation satellite systems (GNSS), in the near future, the four main navigation systems (GPS, BDS, GLONASS and GALILEO) as well as some regional systems such as QZSS and IRNSS will broadcast many signals in different frequency. Some of the signals may need further adjustment. In interim, the traditional hardware GNSS receivers which have high integration density and low flexibility are not suited for signals monitoring especially for those new signals.In order to meet the requirement of monitoring GNSS signals as well as the joint processing of them, a high-flexibility multi-system full-band real-time GNSS software receiver is developed. In addition to a wideband antenna, a RF front-end and a data acquisition card to fulfill down-conversion and AD conversion, the rest of receiver are implemented in an ordinary PC with a GPU. With efficient acquisition and tracking methods, the proposal receiver can process all of the civil signals from four main GNSS and some of the regional systems in real-time, including GPS L1C/A, L2C, L5, L1C, BDS B1, B2, GLONASS Gl, G2, GALILEO ElOS, E5a, E5b, QZSS L1C/A, L2C, L5, and L1C signals. Based on the software architecture, the receiver can provide PVT results, measurement results, and many intermediate data such as correlator outputs and raw bit stream which are necessary for signals monitoring and performance analysis. Meanwhile, the strong flexibility of this receiver makes it easy to expansion and update in the future. The GLONASS modernized signals as well as BDS Phase III signals can be quickly added to current receiver after the release of their interface control document (ICD).By using the proposed software receiver, this paper presents the real-time tracking states of all civil signals, the positioning results of each navigation signal, and the monitoring results of viable GNSS satellites. Finally, since the receiver can handle all the civil GNSS signals in real-time and has a flexible structure, it can be used as a dedicated development platform for various types of navigation research.

Design of GPS base-band processing platform based on FPGA and ARM

Design of rf front end for cavity beam position monitor based on ics *

The Design And Implement Of A Receiver For Fsk Signal

Design Optimization and Implementation of Carrier Tracking Loop for High Sensitivity GPS Receivers

Design and Implementation of High-Precision Timing Module for NR Terminals Based on FPGA

Design and implement of GPS receiver synchronization module based on FPGA

Development and Evaluation of GPS L2C Software Receiver Baseband Signal Processing Module

Implementation of a High-Sensitivity Global Navigation Satellite System Receiver on a System-on-Chip Field-Programmable Gate Array Platform

The Design and Hardware Implementation of OFDM System Receiver Based on FPGA

A $K$ -Band Portable FMCW Radar with Beamforming Array for Short-Range Localization and Vital-Doppler Targets Discrimination

Starx A Gpu Based Multi-System Full-Band Real-Time Gnss Software Receiver

The design of GPS high accurate short timing scale based on FPGA

The Design And Implement Of Gps Software Simulation Platform

Design and Realization of GPS RF Signal Source

Design of Onboard Navigation System Based on ARM Platform

A Real-Time Software GPS Receiver Based on MAX2769

Integrative FPGA Design of GPS Digitized IF Signal Generator

General Radar Signal Simulation,acquisition and Processing System Based on FPGA

C/A Code of GPS Software Receiver Fast Acquisition Based on FPGA

A 180nm fully-integrated dual-channel reconfigurable receiver for GNSS interoperations

Design of triple-band CMOS GPS receiver RF front-end