Abstract:With the development of space technology, functionalities and life span of the spacecraft are increasing, leading to requirement of a greater proportion of fuels. Liquid sloshing in fuel tanks has more unavoidable effect on the spacecraft. During the attitude and orbital maneuvering of the spacecraft, large-scale amplitude liquid sloshing can be excited with liquid merging and splitting. Generally, theoretical, experimental and numerical methods can be used to predict the dynamics of liquid sloshing. However, most theoretical formulas, like the equivalent mechanical model methods, are only valid for liquid sloshing with small amplitude in simple geometrical tanks. Meanwhile, experimental results are difficult to obtain under a low gravity environment and the accurate measurement of nonlinear liquid sloshing is also a challenge. In most actual simulations, numerical simulation are required. In this paper, based on the smoothed particle hydrodynamics (SPH) method which is a Lagrangian mesh-less method, the linear and angular momentum theorem of the particles system are adopted to calculate the force and moment exerted by liquid against the spacecraft accurately, which avoids the accuracy loss of the pressure field. Moreover, aimed at the low computational efficiency of the common computational fluid dynamics (CFD) method, the impact of particle initial spacing on the accuracy of sloshing force and moment calculated is discussed and enough accuracy of global loads can be guaranteed with fewer particles, which greatly improves the computational efficiency. The time-efficiency of the SPH solver is adequate for embedding into a whole-spacecraft simulation system. Finally, in order to verify the validity of the method, results from SPH method are compared with those obtained by a traditional CFD solver for a 3D liquid sloshing case.

Simulation of Lubricating System for Control Momentum Gyroscopes in Spacecraft

Development And Simulation Of Lubrication Test System For Port Plate/Cylinder Block In Axial Piston Pump

Simulation Analysis for Lubrication State of the Thrust Washer Within Straight Planetary Gear Set

Modeling and Control of the Pneumatic Constant Pressure System for Zero Gravity Simulation

The Simulation Study of a New-Type Frictionless Pneumatic Cylinder

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Dynamics and lubrication analyses of a planar multibody system with multiple lubricated joints

Dynamic analysis of large-scale amplitude liquid sloshing in the spacecraft

Dynamic analysis of large-scale amplitude liquid sloshingin the spacecraft

Numerical investigation on performances of a CO2 ejector containing partially miscible lubricant using heterogeneous modeling

Study on the dynamics, relative equilibria, and stability for liquid-filled spacecraft with flexible appendage

Transient dynamic analysis and experimental verification on lubrication regime transition during startup period of non-contacting mechanical seal in liquid oxygen turbopump

Analysis of Liquid Sloshing in Partially Filled Tank of Spacecraft During Maneuver

Numerical Simulation on Interface Evolution and Pressurization Behaviors in Cryogenic Propellant Tank on Orbit

Modeling of Partially Wetting Liquid Film Using an Enhanced Thin Film Model for Aero-Engine Bearing Chamber Applications

Dynamic Modeling and Attitude Control System of Underactuated Fuel Slosh with Flexible Appendages

A Simulation Analysis of Ball Bearing Lubrication Characteristics Considering the Cage Clearance

Three-dimensional numerical analysis and experimental confirmation for investigating the ground-based lateral droplet ejection toward microgravity simulation

Simulation of Lubricant Rheology in Thin Film Lubrication Part I: Simulation of Poiseuille Flow

Dynamics and control of mass-variable liquid-filled spacecraft with combined nonlinear slosh

Numerical Analysis of the Lubrication Performances for Ultra-Thin Gas Film Lubrication of Magnetic Head/Disk with A New Finite Difference Method