Abstract:Friction compensation is particularly important for motion trajectory tracking control of pneumatic cylinders at low speed movement. However, most of the existing model-based friction compensation schemes use simple classical models, which are not enough to address applications with high-accuracy position requirements. Furthermore, the friction force in the cylinder is time-varying, and there exist rather severe unmodelled dynamics and unknown disturbances in the pneumatic system. To deal with these problems effectively, an adaptive robust controller with LuGre model-based dynamic friction compensation is constructed. The proposed controller employs on-line recursive least squares estimation (RLSE) to reduce the extent of parametric uncertainties, and utilizes the sliding mode control method to attenuate the effects of parameter estimation errors, unmodelled dynamics and disturbances. In addition, in order to realize LuGre model-based friction compensation, the modified dual-observer structure for estimating immeasurable friction internal state is developed. Therefore, a prescribed motion tracking transient performance and final tracking accuracy can be guaranteed. Since the system model uncertainties are unmatched, the recursive backstepping design technology is applied. In order to solve the conflicts between the sliding mode control design and the adaptive control design, the projection mapping is used to condition the RLSE algorithm so that the parameter estimates are kept within a known bounded convex set. Finally, the proposed controller is tested for tracking sinusoidal trajectories and smooth square trajectory under different loads and sudden disturbance. The testing results demonstrate that the achievable performance of the proposed controller is excellent and is much better than most other studies in literature. Especially when a 0.5 Hz sinusoidal trajectory is tracked, the maximum tracking error is 0.96 mm and the average tracking error is 0.45 mm. This paper constructs an adaptive robust controller which can compensate the friction force in the cylinder.

Modeling and Control of the Pneumatic Constant Pressure System for Zero Gravity Simulation

Modelling And High-Precision Constant Pressure Control Of The Pneumatic Suspension System

Modeling and Constant Pressure Control of Pneumatic Suspension System for Zero-Gravity Simulation

Development and key technologies of pneumatic suspension system for zero-gravity simulation

Modeling of a pneumatic system for high-accuracy position control

Precision Trajectory Tracking Control of a Pneumatic Cylinder and Output Stiffness Regulation

Design and Characteristics Analysis of a High Precision Pneumatic Proportional Pressure Valve

Modelling and Experimental Verification of Pressure Relief Synchronous Control for Small Trapped Fluid Volumes.

Design and Simulation of Pneumatic Proportional Extra-High Pressure Valve

Simulation Of Controllable Pressure-Clearance Characteristic Of A High Pressure Pneumatic Chamber

Adaptive Robust Posture Control of A 3-Rps Pneumatic Parallel Platform with Unknown Deadzone

Adaptive Robust Motion Trajectory Tracking Control of Pneumatic Cylinders with LuGre Model-Based Friction Compensation

Modeling and Adaptive Robust Posture Control of 3-Rps Pneumatic Parallel Platform

Model-Based Hybrid Control of Combined Active–Passive Vertical Zero-Gravity System

Modeling and Controller Design for an Experimental Test Bench for Aircraft Actuators

A Constant Pressure Cylinder Coupled with a “Zero-Stiffness” Eddy Current Damper

Modeling and Control of A Suspended Gravity Compensation System with Rigid-Elastic Coupling

Design, Analysis, and Experimental Validation of an Active Constant-Force System Based on a Low-Stiffness Mechanism

Modeling and Analysis of Pneumatic Loading System

Control of Soft Pneumatic Actuators with Approximated Dynamical Modeling

Precise control of the piston position and the pressure of cylinder chambers for the pneumatic actuator