Abstract:Median control input,dead volume and leakage flow rate were identified for obtaining precise model parameters of pneumatic servo system. According to the physical phenomenon that the stable pressure values of port A and port B under the same control voltage would be different,the median control input of proportional directional valve could be obtained through minimizing the offset value of two stable pressure ratio curves. According to the physical phenomenon that the pressure responses of port A would be different but the stable pressure values of port A are identical when the pneumatic cylinder is fixed at two ends,the dead volume of rodless pneumatic cylinder could be obtained through equal leakage mass flow rate when equalizing pressure. In order to describe the steep mass flow rate just before the valve port was open and eliminate the noncontinuity between the flow rate equations of leakage and valve orifice,the leakage flow rate was transformed into the leakage throttling area that was fitted by a rational expression. The experimental results indicated that the model uncertainties are reduced,the control accuracy of the adaptive robust controller is improved,and the control input is very smooth through the identification of characteristic parameters and structure parameters.

Design and Characteristics Analysis of a High Precision Pneumatic Proportional Pressure Valve

Design and Simulation of Pneumatic Proportional Extra-High Pressure Valve

Design and Simulation of a High Pressure Proportional Pneumatic Pressure Reducing Valve

Modeling and characteristics investigation on a new pneumatic proportional pressure valve

Modelling And High-Precision Constant Pressure Control Of The Pneumatic Suspension System

Principle and Characteristics of On/off Piloted Pneumatic Extra-High Pressure Reducing Valve

Modeling of a pneumatic system for high-accuracy position control

Development of a novel high pressure electronic pneumatic pressure reducing valve

Hydraulic-feedback Proportional Valve Design for Construction Machinery

Identification of Characteristic Parameters and Structure Parameters in Pneumatic Servo Control

Research on control characteristic and compensation of water hydraulic proportional pressure relief valve

Pressure Control of the Proportional Directional Control Valve Test Rig Based on the Fuzzy Proportional-Integral-Double-Integral Controller

Simulation and Experiment on Static Characteristic of Water Hydraulic Proportional Pressure Relief Valve

Pneumatic Resistance Network Analysis and Dimension Optimization of High Pressure Electronic Pneumatic Pressure Reducing Valve

Model And Optimal Design Of Pneumatic High-Speed On/Off Valve

Experiment on Proportional Pressure Control of Water Hydraulic System for Water-assisted Injection Molding

Design of High Pressure Reduction with Expander Pneumatic System' s Controller

Simulation Of Controllable Pressure-Clearance Characteristic Of A High Pressure Pneumatic Chamber

Modeling and Constant Pressure Control of Pneumatic Suspension System for Zero-Gravity Simulation

Study on ultrahigh pressure and large flow rate pneumatic on-off valve

High Performance Pressure Control for the Hydraulic Press Based on the Soft Relief Fuzzy Pid Controller