Abstract:Abstract Local corner smoothing method is commonly adopted to smooth linear (G01) tool path segments in computer numerical control (CNC) machining to realize continuous motion at transition corners. However, because of the highly non-linear relation between the arc-length and the spline parameter, and the challenge to synchronize the tool tip position and tool orientation, real-time and high-order continuous five-axis tool path smoothing and interpolation algorithms have not been well studied. This paper proposes a real-time C3 continuous corner smoothing and interpolation algorithm for five-axis machine tools. The transition corners of the tool tip position and tool orientation are analytically smoothed in the workpiece coordinate system (WCS) and the machine coordinate system (MCS) by C3 continuous PH splines, respectively. The maximum deviation errors of the smoothed tool tip position and the tool orientation are both constrained in the WCS. An analytical synchronization algorithm is developed to guarantee the motion variance of the smoothed tool orientation related to the tool tip displacement is also C3 continuous. The corresponding real-time interpolation method is developed with a continuous and peak-constrained jerk. Simulation results verify that the maximum deviation errors caused by the tool path smoothing algorithm are constrained, and continuous acceleration and jerk of each axis are achieved along the entire tool path. Comparisons demonstrate that the proposed algorithms achieve lower amplitude and variance of acceleration and jerk when compared with existing methods. Experiments show that the proposed five-axis corner smoothing and interpolation algorithms are serially executed in real-time with 0.5-ms cycle.

Real-Time B-Spline Interpolator with Look-Ahead Scheme for High-Speed CNC Machine Tools

A Real-Time Dual NURBS Interpolator with Optimised Control of Flexible Acceleration and Deceleration for Five-Axis CNC Machining

Adaptive Prospective Interpolation Method for High Speed Machining of Micro Line Blocks Based on the Cubic Polynomial Model

LOOK-AHEAD ALGORITHM FOR VELOCITY CONTROL BASED ON PARAMETERIZED CURVE INTERPOLATOR

A smoothing method of continuous line-segment path in CNC machining based on real-time transformation of interpolation points

A smooth tool path generation and real-time interpolation algorithm based on B-spline curves

Application of an Optimized Sampled-data Interpolation Algorithm in Open-loop CNC

A New Linear Interpolation Method with Lookahead for High Speed Machining

A Look-Ahead and Adaptive Speed Control Algorithm for Parametric Interpolation

A Fine-Interpolation-based Parametric Interpolation Method with a Novel Real-Time Look-Ahead Algorithm

High-speed Real-Time Interpolation of Cubic Uniform B-spline Curve

AXIS-BASED LOOK-AHEAD INTERPOLATOR FOR MACHINING OF SURFACES REPRESENTED BY NURBS CURVES

Smooth Non-Uniform Rational B-spline (NURBS) Machining with Kinematic Limit for Short Linear Segments

A Real-Time C3 Continuous Tool Path Smoothing and Interpolation Algorithm for Five-Axis Machine Tools

A novel time-optimal linear toolpath smoothing method based on airthoid and circular splines for CNC machining

A Dual NURBS Curve Five-Axis Interpolator with Interval Division under Axial Kinematic Constraints

An Interpolation Method for the Open CNC System Based on EPM

New look-ahead algorithm for velocity control in high speed machining

Research of High Performance Self-adaptive Interpolation Based on Open Architecture CNC

Research on Inverse Evaluation Mechanism in Toolpath Generation Based on Global Interpolation Simulation

A real-time interpolation strategy for transition tool path with C2 and G2 continuity