Abstract:Increasing the power conversion efficiency (PCE) of kesterite Cu2ZnSn(S,Se)4 (CZTSSe) solar cells has remained challenging over the past decade, in part due to open-circuit voltage (VOC)-limiting defect states at the absorber/buffer interface. Previously, we found that substituting the conventional CdS buffer layer with In2S3 in CZTSSe devices fabricated from nanoparticle inks produced an increase in the apparent doping density of the CZTSSe film and a higher built-in voltage arising from a more favorable energy-band alignment at the absorber/buffer interface. However, any associated gain in VOC was negated by the introduction of photoactive defects at the interface. This present study incorporates a hybrid Cd/In dual buffer in CZTSSe devices that demonstrate an average relative increase of 11.5% in PCE compared to CZTSSe devices with a standard CdS buffer. Current density-voltage analysis using a double-diode model revealed the presence of (i) a large recombination current in the quasi-neutral region (QNR) of the CZTSSe absorber in the standard CdS-based device, (ii) a large recombination current in the space-charge region (SCR) of the hybrid buffer CZTSSe-In2S3-CdS device, and (iii) reduced recombination currents in both the QNR and SCR of the CZTSSe-CdS-In2S3 device. This accounts for a notable 9.0% average increase in the short-circuit current density (JSC) observed in CZTSSe-CdS-In2S3 in comparison to the CdS-only CZTSSe solar cells. Energy-dispersive X-ray, secondary-ion mass spectroscopy, and grazing-incidence X-ray diffraction compositional analysis of the CZTSSe layer in the three types of kesterite solar cells suggest that there is diffusion of elemental In and Cd into the absorbers with a hybrid buffer. Enhanced Cd diffusion concomitant with a double postdeposition heat treatment of the hybrid buffer layers in the CZTSSe-CdS-In2S3 device increases carrier collection and extraction and boosts JSC. This is evidenced by electron-beam-induced current measurements, where higher current generation and collection near to the p-n junction is observed, accounting for the increase in JSC in this device. It is expected that optimization of the heat treatment of the hybrid buffer layers will lead to further improvements in the device performance.

Cu(In,Ga)Se2 Solar Cells with Double Layered Buffers Grown by Chemical Bath Deposition

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

High-Efficiency Cu(In,Ga)Se₂ Thin Film Solar Cells Using ZnS and CdS Buffer Layers

Zinc Chloride‐treated Indium Sulfide as Buffer Layer for Cd‐free Antimony Selenide Solar Cells

Interface Engineering for High-Efficiency Solution-Processed Cu(In,Ga)(S,Se)2 Solar Cells via a Novel Indium-Doped CdS Strategy

Atomic-Scale Interface Modification Improves the Performance of Cu(In1- xGax)Se2/Zn(O,S) Heterojunction Solar Cells

Improvement of the Electrical Properties of a Cu(In,Ga)Se₂ Solar Cell Based on a ZnS Buffer Layer from Radio Frequency Magnetron Sputtering

Investigation of Cu(In, Ga)Se2 solar cell performance with non-cadmium buffer layer using TCAD-SILVACO

Impact on generation and recombination rate in Cu2ZnSnS4 (CZTS) solar cell for Ag2S and In2Se3 buffer layers with CuSbS2 back surface field layer

Improvement of the CIGS solar cell performance: structure based on a ZnS buffer layer

Heterojunction Interface Passivation Strategy for Cu(In1-x,Gax)Se2 Solar Cell with Nano-Level Engineering of Zn-based Buffer Structure Via Atomic Layer Deposition Method

Enhanced Carrier Collection in Cd/In-Based Dual Buffers in Kesterite Thin-Film Solar Cells from Nanoparticle Inks

Interface Formation between CdS and Alkali Postdeposition-Treated Cu(In,Ga)Se2 Thin-Film Solar Cell Absorbers-Key To Understanding the Efficiency Gain

Study on the Performance of Oxygen-Rich Zn(O,S) Buffers Fabricated by Sputtering Deposition and Zn(O,S)/Cu(In,Ga)(S,Se) 2 Interfaces

Numerical Simulations on CZTSSe-Based Solar Cells with GaSe as an Alternative Buffer Layer Using SCAPS-1D

Metal Precursor with Bi-Layer Indium for Cu(In,Ga)Se2 Thin Film Preparation

Reactively Sputtered CdS:O Buffer Layers for Substrate Sb2Se3 Solar Cells

Mechanism‐Based Approach of CdS/Cu(In,Ga)Se2 (CIGS) Interfaces for CIGS Solar Cells Through Deposition in Different Stages of Continuous Chemical Bath Deposition Reaction: Key to Achieving High Photovoltaic Performance

Sb2Se3 solar cells employing metal-organic solution coated CdS buffer layer

Deposition and Property Characterization InxSy Buffer Layers in Cu (In, Ga) Se2 Solar Cells