Abstract:It is highly desired to efficiently dissipate the high heat flux generated in electronics. A novel hybrid microchannel heat sink combining manifold with secondary oblique channels (MMC-SOC) has been proposed and studied numerically in our previous work. The current study conducts the fabrication and experimental test of the hybrid microchannel heat sink using dielectric fluid HFE-7100. The volume flow rate qv ranges from 211 to 580 mL/min, with channel Reynolds numbers between 278 and 905 for heat fluxes q'' = 20, 25, 30 and 35 W/cm2. The results indicate that the MMC-SOC heat sink can simultaneously reduce the thermal resistance Rt and pressure drop ∆P. For heat sinks with channel height Hc = 60 μm, an 11% reduction in ∆P and a 24% reduction in Rt are obtained compared to conventional manifold microchannel (MMC) heat sink for qv = 580 mL/min and q'' = 20 W/cm2. As qv increases, the ratio (Rt/Rt0) becomes smaller and (∆P/∆P0) becomes larger, which indicates an enhanced ability of reducing Rt and a suppressed ability of reducing ∆P. For the maximum qv = 580 mL/min and q'' = 35 W/cm2, the MMC-SOC heat sink can maintain a maximum chip temperature of 53 °C with a pressure drop of only 3.77 kPa. Moreover, the proposed MMC-SOC heat sink has a lower pressure drop compared to MMC heat sink owing to a reasonable design, even though the Reynolds number of the MMC-SOC heat sink reaches up to 883. This provides a very promising scheme for safe and efficient single-phase microchannel cooling used in the thermal management of electronics with high heat flux. In addition, the ratio (Rt/Rt0) will increase with increasing heat flux and increasing the flow rate becomes an effective way to further reduce the chip surface temperature at operating conditions with higher heat flux.

Experimental Research on A Honeycomb Microchannel Cooling System

A honeycomb microchannel cooling system for microelectronics cooling

A Honeycomb Micro Channel Cooling System For Electronics Cooling

Experimental Study On A Honeycomb Micro Channel Cooling System

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Experiment Investigation on a Honeycomb Micro-channel Based Cooling System

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Thermal Performance of the Multilayered Honeycomb Microchannel Heat Sink

Experimental Study on the Multilayered Honeycomb Microchannel Heatsink Design Based on the Flow Disruption

Cooling Behavior In A Novel Heat Sink Based On Multilayer Staggered Honeycomb Structure

Experimental Study on Cooling Performance of a Hybrid Microchannel and Jet Impingement Heat Sink

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Hybrid Mini/Micro-Channel Heat Sink Using Liquid Metal and Water As Coolants

Experimental Investigation of Heat Transfer Performance for a Novel Microchannel Heat Sink

Experimental study on single-phase hybrid microchannel cooling using HFE-7100 for liquid-cooled chips

Numerical Study of Laminar Heat Transfer and Pressure Drop Characteristics in A Water-Cooled Minichannel Heat Sink

Experimental and Numerical Study on the Performances of Mini-Channel Heat Sinks

Thermal-hydraulic Performance of Microchamber Heat Sinks with Run-Through Metal Pillar Arrays and Hot-Spot Oriented Manifold Inlets

Pool boiling heat transfer of dual-scale porous microchannel for high-power electronics cooling

Experimental Study on Thermosyphon Heat Sink for Cooling of Electronic Apparatus

A bio-inspired fractal microchannel heat sink with secondary modified structure and sub-total-sub fluid transmission mode for high heat flux and energy-saving heat dissipation