Abstract:Two-dimensional Ti2(PO4)2F nanosheets were synthesized with an ionic liquid (IL) containing PF6 ([Bmim]PF6) via a hydrothermal method. In comparison, only anatase titanium dioxide (TiO2) nanoparticles were obtained when changing the type of anion ([Bmim]Br or [Bmim]BF4) under the same conditions, suggesting that the anion type could greatly affect the crystalline phase, particle size, specific surface, and morphology of the final products; two-dimensional nanosheets were obtained in [Bmim]PF6, whereas nanocrystals with a relatively large surface were formed in the latter two ILs, as revealed by X-ray diffraction, nitrogen gas sorption, scanning electron microscopy, and transmission electron microscopy measurements. 1H and 19F nuclear magnetic resonance examinations of the fresh and recycled ILs suggest that the IL with the PF6 anion experienced complete hydrolysis, which could be the key factor for the formation of such unique Ti2(PO4)2F nanosheets. The electrochemical performances of such Ti2(PO4)2F nanosheets were evaluated as anode materials in lithium-ion batteries (LIBs) in comparison to TiO2 nanomaterials. The rate capability and cycling performance of the Ti2(PO4)2F electrode outperformed the other two electrodes studied, as illustrated by cyclic voltammetry curves, charge/discharge behavior, and long cycling test, which is mainly due its unique layered structure and low surface area, which resulted in low volume change. The Ti2(PO4)2F electrode derived from [Bmim]PF6 displays a steady reversible capacity of 170 mAh/g and high cycling stability with over 70% capacity retention after 100 cycles. The synthesis of the controllable crystalline phase and morphology of Ti2(PO4)2F nanomaterials with such ILs paves a useful route to prepare such alternative anode materials for LIBs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acs.energyfuels.1c02635.1H NMR of [Bmim]Br, [Bmim]BF4, and [Bmim]PF6 before and after the hydrothermal treatment process (Figure S1), 19F NMR of [Bmim]BF4 before and after the hydrothermal treatment process (Figure S2), pH values of the reaction mixture before and after thermal treatment (Table S1), EDX analysis of Ti2(PO4)2F nanosheets, showing O, F, Ti, and P elements (Figure S3), and EDX mapping of Ti2(PO4)2F nanosheets, showing the uniform distribution of P and Ti elements (Figure S4) (PDF)This article has not yet been cited by other publications.

Preparation of Titanium Dioxide, Lithium Titanium Oxide and Lithium Iron Phosphate from Ilmenite

A Novel Process for Producing Synthetic Rutile and LiFePO4 Cathode Material from Ilmenite

Preparation of lithium iron phosphate with superior electrochemical performances from titanium white by-product ferrous sulfate

Recovery of iron from titanium white waste for the preparation of LiFePO 4 battery

Clean and efficient synthesis of LiFePO4 cathode material using titanium white waste and calcium dihydrogen phosphate

Preparation and characterization of Ti4+-doped LiFePO4 cathode materials for lithium-ion batteries

Effect of Ti content on preparation of LiFePO4 cathode from FeSO4·7H2O waste residue

Excess capacity on compound phases of Li2FeTiO4 composite cathode materials synthesized by hydrothermal reaction using optional titanium sources to boost battery performance

Hydrothermal Synthesis of Li4Ti5O12/TiO2 Nano-composite As High Performance Anode Material for Li-Ion Batteries

Synthesis and Characterization of Nanometric Iron and Iron-Titanium Oxides by Mechanical Milling:

Li4Ti5O12 Prepared by a Modified Citric Acid Sol–gel Method for Lithium-Ion Battery

Preparation of Doped Iron Phosphate by Selective Precipitation of Iron from Titanium Dioxide Waste Acid

Research on Preparation of Nano-porous Lithium Iron Phosphate for Lithium-ion Battery Electrode Materials

Open-Structured Oxyfluorinated Titanium Phosphate Nanosheets Synthesized with the Assistance of an Ionic Liquid and Their Use as an Anode in Lithium-Ion Batteries

A novel process for preparation of titanium dioxide from Ti-bearing electric furnace slag: NH4HF2-HF leaching and hydrolyzing process

Effects of Titanium Incorporation on Phase and Electrochemical Performance in LiFePO4 Cathode Material

Basic Research on Selective Extraction of Iron from Titanium Dioxide Waste Acid to Prepare Iron Phosphate Precursors

Unveiling the Formation Mechanism and Phase Purity Control of Nanostructured Li 4 Ti 5 O 12 via a Hydrothermal Process

Solvothermal Synthesis and the Electrochemical Property of Nano-sized TiO2 Anode Materials for Lithium-ion Batteries

Cleaner and effective recovery of metals and synthetic lithium-ion batteries from extracted vanadium residue through selective leaching

Preparation of nanosized Li4Ti5O12 as anode material for lithium-ion batteries via ion-exchange method