The Influence of Α-Al2o3 Addition on Microstructure, Mechanical and Formaldehyde Adsorption Properties of Fly Ash-Based Geopolymer Products

Yi Huang,Minfang Han
DOI: https://doi.org/10.1016/j.jhazmat.2011.07.029
IF: 13.6
2011-01-01
Journal of Hazardous Materials
Abstract:Fly ash-based geopolymer with α-Al(2)O(3) addition were synthesized and used to remove formaldehyde from indoor air. The microstructure, mechanical and formaldehyde adsorption properties of the geopolymer products obtained were investigated. The results showed that α-Al(2)O(3) addition with appropriate amount (such as 5 wt%) increased the geopolymerization extent, resulting in the increase of surface area and compressive strength. In addition, the improvement of structural ordering level for geopolymer sample with 5 wt% α-Al(2)O(3) addition was found through FTIR analysis. By contrast, excessive addition (such as 10 wt%) had the opposite effect. The test of formaldehyde adsorption capacity confirmed that fly ash-based geopolymer product exhibited much better property of adsorbing indoor formaldehyde physically and chemically than fly ash itself. The surface area was an important but not unique factor influencing the adsorption capacity of geopolymers.
What problem does this paper attempt to address?