Abstract:The phase equilibrium of Mg-Cu-Ca ternary system at 350 degrees C were investigated using thirteen key samples. Scanning electron microscopy (SEM) equipped with energy-dispersive spectroscope (EDS) was employed to investigate equilibrium relationships and phase compositions in alloy samples. Powder X-ray diffraction (XRD) technique was used to analyze the crystal structures of new found phases. Two unreported ternary phases, P1 and Mg25-xCu75Cax were observed and investigated for the first time. The compound P1 has a narrow solid homogeneity ranged from about Mg25Cu35Ca40 to Mg30Cu30Ca40 (in at. %). The solid solubility limit of the compound Mg25-xCu75Cax was found to be 8.03 <= x(Ca) <= 16.67 with constant value of about 75 at. % Cu at 350 degrees C. The 2q of fourteen diffraction peaks of new phase P1 were determined to be 23.0 degrees, 35.9 degrees, 37.3 degrees, 38.9 degrees, 42 degrees, 44 degrees, 47 degrees, 52.5 degrees, 54 degrees, 56.7 degrees, 62.3 degrees, 66.8 degrees, 68.2 degrees and 75.4 degrees. The 2q of ten diffraction peaks of the new compound Mg25-xCu75Cax were confirmed to be 20.5 degrees, 21.2 degrees, 34.7 degrees, 35.7 degrees, 42.3 degrees, 43.3 degrees, 44.8 degrees, 47.3 degrees, 50.5 degrees and 74.5 degrees. The maximum solid solubility of Ca in the terminal compound MgCu2 was found to be 8.83 at. % at 350 degrees C. Ternary maximum solid solubility of binary terminal compounds Mg2Ca, Mg2Cu, Cu5Ca and CuCa were less than 2 at. %. In addition, eight three-phase equilibrium relationships were determined in the present work. (C) 2019 Elsevier B.V. All rights reserved.

Application of High Temperature Quantitative X-Ray Powder Diffraction on Determination of Ternary System

Thermal conductivity measurement of phase-change material near melting point based on perturbation method

Quantitative Phase Analysis In The Ti-Al-C Ternary System By X-Ray Diffraction

Experimental Determination of the Phase Equilibrium in the Mg–Cu–Ca Ternary System at 350 °C

Experimental isothermal section of the system Cr-Nb-Ru at 1100 °C

Experimental Investigation of Phase Equilibria in the Co-Ta-Si Ternary System

Experimental Investigation of Isothermal Sections and Thermodynamic Modeling on the Cu-Nb-Ni System

Phase Equilibria of the Cu-Se-Te Ternary System

The Cu–Te system: Phase relations determination and thermodynamic assessment

Experimental Measurement on the Phase Equilibria of the Mg–Ag–Cu Ternary System at 350 and 400 °C

Experimental study on phase relations in the Al-Mo-Nb ternary system

Phase Equilibria of the Sn–Zn–Cu Ternary System

Experimental Investigation and Thermodynamic Assessment of Phase Equilibria in the Al-Ta-V Ternary System

Experimental Investigation of Phase Equilibria in the Nb-Si-V Ternary System

Experimental determination of isothermal sections for the Co-rich corner of the Co-Cr-Ti system at 800 and 900 °C

Phase equilibria in Co−Al−Re ternary system at 1100 and 1300 °C

Thermal Analysis by Means of Differential Scanning Calorimetry of the Characteristic Thermodynamic Temperatures of a Cu-Zr-Al Bulk Metallic Glass

Experimental study of the phase relations in the Fe–Cr–Si ternary system at 700°C

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

Phase Equilibria of Sn–Sb–Cu System

Phase equilibria in Ni–Ti–Ta ternary system