Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Investigation Of Pemfc Stack Operating At Elevated Temperature

Experimental Investigation and Comprehensive Analysis of Performance and Membrane Electrode Assembly Parameters for Proton Exchange Membrane Fuel Cell at High Operating Temperature

Investigation of the Ambient Temperature Influence on the PEMFC Characteristics: Modeling from a Single Cell to a Stack

Experimental study on the dynamic response of voltage and temperature of an open-cathode air-cooled proton exchange membrane fuel cell

Several Important Aspects of H2-air PEMFC Engine

Theoretical and Experimental Study of a Fuel Cell Stack Based on Perfluoro-sulfonic Acid Membranes Facing High Temperature Application Environments

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Performance of the 5 kW H2-air proton exchange membrane fuel cell

Investigation of Heating and Cooling in a Stand-Alone High Temperature PEM Fuel Cell System

Gel-state Polybenzimidazole Proton Exchange Membranes with Flexible Alkyl Sulfonic Acid Side Chains for a Wider Operating Temperature Range (25–240 °C)

Influence of cathode air supply mode on the performance of an open cathode air-cooled proton exchange membrane fuel cell stack

Investigation of non-uniform temperature distribution in air-cooled proton exchange membrane fuel cells with multizone temperature measurement

Thermodynamic Modeling and Performance Analysis of Vehicular High-Temperature Proton Exchange Membrane Fuel Cell System

Effects of operating conditions on the performance uniformity of the proton-exchange membrane fuel cell stack

Experimental study on the thermal management of an open-cathode air-cooled proton exchange membrane fuel cell stack with ultra-thin metal bipolar plates

Proton exchange membrane fuel cell from low temperature to high temperature: Material challenges

High ion exchange capacity perfluorosulfonic acid resine proton exchange membrane for high temperature applications in polymer electrolyte fuel cells

EXPERIMENT ON HUMIDIFIER OF DETACHMENT-INTEGRATION STACK

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Degradation Investigation of Electrocatalyst in Proton Exchange Membrane Fuel Cell at a High Energy Efficiency

Advancing heat management in proton-exchange membrane fuel cells through hybrid nano-composite phase change materials