Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Investigation of the Ambient Temperature Influence on the PEMFC Characteristics: Modeling from a Single Cell to a Stack

Performance Analysis of a Proton-Exchange Membrane Fuel Cell Battery: The Effect of Ambient Temperature

Thermal characteristics of an air‐cooled open‐cathode proton exchange membrane fuel cell stack via numerical investigation

Performance of PEMFC stack at elevated temperature

Investigation of the Non-Uniform Distribution of Temperature in Air-Cooled Proton Exchange Membrane Fuel Cells with a Multizone Temperature Measurement

Investigation of the Temperature-Related Performance of Proton Exchange Membrane Fuel Cell Stacks in the Presence of CO

A single-phase, non-isothermal model for PEM fuel cells

A model predicting performance of proton exchange membrane fuel cell stack thermal systems

Numerical Analysis of Static and Dynamic Heat Transfer Behaviors Inside Proton Exchange Membrane Fuel Cell

Investigation Of Pemfc Stack Operating At Elevated Temperature

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Experimental Investigation and Comprehensive Analysis of Performance and Membrane Electrode Assembly Parameters for Proton Exchange Membrane Fuel Cell at High Operating Temperature

Modeling Water and Thermal Transients Inside Proton Exchange Membrane for Vehicle Application Fuel Cells

Study on the Heat and Mass Transfer Mechanisms of Liquid-Cooled PEMFC Stacks Based on Non-Isothermal Model

Modeling and Analysis of Thermal-Management Impacts on Transient Performances of Pem Fuel Cells

Investigation of Thermal Influence on the Assembly of Polymer Electrolyte Membrane Fuel Cell Stacks

Investigation of non-uniform temperature distribution in air-cooled proton exchange membrane fuel cells with multizone temperature measurement

Advanced Study of Non-Uniform Cell Voltage Distribution for a PEMFC Stack

Operation Characteristics of Air-Cooled Proton Exchange Membrane Fuel Cell Stacks under Ambient Pressure

Thermal Analysis and Management of Proton Exchange Membrane Fuel Cell Stacks for Automotive Vehicle

Stack-level Analysis of the Performance Variation in Air-Cooled PEMFC with Z-type Anode Manifold