Abstract:Exhaust gas temperature in coal-fired power plants can reach approximately 120 °C to 140 °C, with the thermal energy accounting for approximately 3% to 8% of the total input energy. Therefore, the heat recovery of exhaust flue gas can improve the thermal efficiency of coal-fired power plants. Currently, the waste heat of flue gas can be recovered by installing an extra heat exchanger, also called low-temperature economizer (LTE), at the end of the boiler flue to heat a part of the condensed water. Extra work can then be obtained by saving the extracted steam and using it to heat the condensed water. However, the temperature of exhaust flue gas is only about 130 °C, which causes the flue gas to heat only the condensed water in the #7 and #8 regenerative heaters. Thus, the energy savings are inconspicuous. This paper proposes a novel flue gas heat recovery system to dramatically increase the temperature of flue gas in the LTE by comprehensive optimization of the air preheater and the LTE. A low-temperature (LT) air preheater can be installed after the LTE in the novel system so that the flue gas can be divided into two parts to heat the air. Simultaneously, the LTE can be installed between the two air preheaters, causing the temperature of flue gas in the LTE to reach above 170 °C. Hence, the temperature of condensed water in the LTE can be increased significantly. In addition, the LTE can replace the high-pressure extracted steam from the turbine, resulting in better energy savings. We also conduct case studies based on a typical 1,000 MW supercritical power generation unit in China. The results indicate better performance of the novel system, with a decrease in exergy loss and improvement in heat transfer characteristics. The reduction in standard coal equivalent of the novel system can reach 3.31g/kWh, nearly 2.4 times that of the system that uses conventional waste heat recovery. Our achievements provide a promising waste heat recovery methods of the utility boiler flue gas.

Experimental Study on the Tubular Furnace with Regenerative Combustion

The Development of Regenerative Mill Furnace and It's Merits and Demerits

Experimental Study of the Condensation Heat Transfer Performance of Flue Gases in a Heating-and-power Cogeneration System

Experimental study of the effect of a radiant tube on the temperature distribution in a horizontal heating furnace

INVESTIGATION OF HIGH TEMPERATURE AIR COMBUSTION OF SELF-REGENERATOR

Experiments on Self-Regenerative High Temperature Air Combustion

The Merits and Demerits and Combustion Thermo-Atmosphere of Regenerative Mill Furnace

Experimental Study Of Natural Gas Combustion Flue Gas Waste Heat Recovery System Based On Direct Contact Heat Transfer And Absorption Heat Pump

Experimental Investigation on Solution Regeneration Performance and Coefficients in Full-Open System for Heat and Water Recovery of Flue Gas

Experimental study and numerical simulation on the gas-solid two-phase flow field in the furnace of a 300MW tangentially fired utility boiler

Waste Heat Recovery from Converter Gas by a Filled Bulb Regenerator: Heat Transfer Characteristics

Numerical modeling and parameter optimization of the combustion chamber in a tower-type zinc refining furnace

Design and Experimental Study of a New Type Self-heat-storage Burner

Optimum Design of Contiguous Regenerator Burner

Study on characteristics of regenerative high temperature air production

A Novel Flue Gas Heat Recovery System Integrated With Air Preheating in a Utility Boiler

On-Site Experimental Study on Low-Temperature Deep Waste Heat Recovery of Actual Flue Gas from the Reformer of Hydrogen Production

Research on Thermodynamic Characteristics of the Saturated Flue Gas Waste Heat Recovery to Reduce Turbine Extraction Steam

Experimental Study on Flow and Heat Transfer Performance of Condensing Gas-Fired Boiler

Combustion of electronic wastes using a drop tube furnace

Heat Transfer Characteristics of High-Temperature Dusty Flue Gas from Industrial Furnaces in a Granular Bed with Buried Tubes