Abstract:Single-phase string inverter has been widely applied to grid-tied photovoltaic (PV) rooftop applications for its renewable energy. However, the inherent attribute of intermittency in solar energy may induce instability and unqualified power. To meet the grid-interconnection standards, high demands of efficiency and harmonic distortion need to be imposed on DC/AC inverters. Conventional soft-switching inverters used to sacrificing auxiliary resonant circuits to exchange for soft switching. This requires additional costs as well as sufficient dead time to discharge junction capacitances of all switches, which exacerbates total harmonics distortion (THD) induced by dead-time effect. To improve, this paper proposes a partial soft-switching silicon carbide (SiC) -based active neutral-point-clamped (ANPC) inverter, which possesses high efficiency, eligible dead time, and no auxiliaries. 650-V SiC MOSFET is adopted for its smaller output capacitance compared with Si device. Hybrid PWM modulation is utilized to achieve partial soft switching. Whereas, the soft switching realization range and power losses highly depend on the dead time. To achieve less power loss and improved dead time effect, this paper proposes a loss model-based dead time algorithm through a Power Loss VS. Dead Time mathematical loss model. Moreover, the mechanism of the dead time affected by soft switching is explored. The transition modes, dead time configurable boundaries, and design procedure are also analyzed in detail. A 1-kW prototype is demonstrated with the input of 800 V and the rated output of 220 V/ 4.5 A. Its efficiency could reach 99.6% with THD=0.95% at full power level.

Loss-Model Based Interleave Technique To Improve The Efficiency Of Micro-Inverter

Research on High Efficient Micro PV Grid-connected Inverter with Low Input Voltage

Modeling and Optimization of a Zero-Voltage Switching Inverter for High Efficiency and Miniaturization

Loss Unbalance Issue Of The Full-Bridge Inverter With Reactive Power Injection

Mission Profile Based Sizing of Igbt Chip Area for Pv Inverter Applications

Energy Efficiency Enhancement in Full-Bridge PV Inverters with Advanced Modulations

An Overview of Photovoltaic Microinverters: Topology, Efficiency, and Reliability

APPLICATION AND LOSS ANALYSIS OF ACTIVE COMMON-NOISE CANCELLER FOR ON-GRID TRANSFORMERLESS PV INVERTER SYSTEM

Efficiency Enhanced Burst Mode Control Strategy for Microinverters

A comparison of soft and hard-switching losses in three phase micro-inverters

An Optimal Control Method for Grid-Connected Photovoltaic Micro-Inverter to Improve the Efficiency at Light-Load Condition

Efficiency Optimization of Grid-connected PV Inverter Based on Modulation Scheme

An efficiency optimization strategy of PV/DC modular integrated structure under power mismatch condition

A Variable Switching Frequency Multimode Control Scheme for Single-Phase Grid-Tied Multilevel PV Microinverters

An Improved Inverter for a Grid-Connected Photovoltaic Power System

A Model for Inverter Loss Considering Output Current Ripple

Power Losses in Two- and Three-Level Three Phase Photovoltaic Inverters Equipped with IGBTs

A partial soft-switching SiC-based ANPC single-phase inverter with loss model-based dead time optimization for grid-tied PV systems

Quasi-Online Modeling Method of the Power Inverter Losses Based on IGBT Offline Test Platform

A Control Strategy Based on Intermediate Bus Voltage Information for Wide-Range High-Efficiency Step-Up DC-DC Converters.

Power Allocation for Energy Stored Quasi-Z-Source Inverter Based on the Power Loss Modelling