Abstract:Co-based diamond tools are widely appreciated for their exceptional mechanical properties and good holding ability for diamonds. However, the reliance on cobalt (Co) poses challenges due to its high cost and scarcity as a strategic resource. A potential alternative is the Fe–Co–Cu alloy, emerging as a promising substitute for Co matrix alloys. In this work, hot-press sintering was utilized to create pure matrix and diamond tools utilizing Fe–Co–Cu pre-alloyed powders of varying compositions as raw materials without the use of any sintering additives. The investigation explores the influence of different Fe: Cu ratios on the mechanical properties of diamond tools produced from Fe–Co–Cu alloys, focusing on the diamond holding force, microstructure, and phase structure evolution. Results indicate that at a Co content of 15 wt% and Fe: Cu ratios ranging from 7.5:1 to 1:7.5, the Fe–Co–Cu alloy's phase structure primarily comprises α-Fe and a Cu-rich phase. Co predominantly exists in α-Fe as a solid solution. As the Fe: Cu ratio decreases, the alloy's phase structure gradually transitions from α-Fe to a Cu-rich phase, accompanied by a progressive decline in both bending strength and hardness, while the densities gradually increase. The matrix's holding force on the diamond exhibits an increasing and then diminishing trend, peaking at the Fe: Cu ratio of 6:1. The Fe–Co–Cu alloy sintered by hot-pressing has a nearly equiaxed grain structure with no obvious texture.

Study on the Preparation of the Prealloyed Powder and Its Application for Diamond Tools

Preparation and Performance of Prealloyed Powder for Laser Welding Diamond Tools

Preparation of prealloyed powder for matrix of diamond tools

Preparation and granularity control of Fe-Co-Cu prealloyed powder

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Preparation of prealloyed powder for diamond tools by coprecipitation-thermal decomposition method

Preparation and Characterization of Ni-Co Alloyed Powder Used in Diamond Tools

Effect of Fe: Cu ratio on microstructure and mechanical properties of Fe-Co-Cu-based diamond tools

Sintering Densification of Cu/Al2O3p Nano-Composite Powders by Electroless Copper Plating

Influence of Elements Powder Pre-Alloying Technology on Microstructure and Property of Sintered Alloy-Steel

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

Effects of CuSn on the Diamond Particle Holding Force of Pressureless Sintered FeCuCo-based Diamond Tools

Characterization of Iron – Based Partial Pre - Alloyed Powders as Matrix Materials for Diamond Tools

Study on Magnetic Properties and Nanocoating Structure of Co-Fe-P Alloy Coatings Obtained by Electroless Deposition

Effect of Chromium on Sintering Structure and Properties of Iron-based Prealloyed Powder

Copper-manganese based prealloy powder for metal-diamond soldering, and its prodn. method

Preparation of pre- alloyed powder and it's application in diamond tools

Preparation of W-Ni-Fe nanocrystalline prealloyed powder

Preparation and reparation and mechanical properties of nanocobalt coated AL2O3-TIC composites

Preparation and characterization of fibrous Ni-Co alloy powders by thermal decomposition of solid solution of complex Ni-Co oxalates

Microstructure and mechanical properties of Co-containing Ti-48Al alloys prepared from irregular pre-alloyed powder