Abstract:BACKGROUND: Pulse wave monitoring is widely used to evaluate the physiological and pathological states of the cardiovascular system. OBJECTIVE: High-sensitivity ring sensors were designed, and a simultaneous acquisition platform based on National Instruments T-Clock technology (NI-TCLK) was used to achieve simultaneous pulse detection using both the traditional method and the magnetic induction phase shift (MIPS) method. METHODS: The excitation signal had a frequency of approximately 10.7 MHz and power of about 20 dBm. A total of 30 volunteers (adults, aged 20-30 y) were selected to corroborate the feasibility of our measurement system. The subjects wore the proposed sensor on their right-hand forefingers and for reference, the piezoelectric pulse sensor on the left-hand forefinger. The pulse waves of these 30 subjects were measured over 2 min each. RESULTS: The phase shift of the magnetic induction detection signal ranged from 0.6-0.8 degrees. Comparison of detection results for the same subject between the two methods showed that the pulse rate measured by magnetic induction exhibited fewer deviations and better stability than the traditional method. In addition, spectral analysis indicated that the pulse frequencies obtained using the 2 methods were concentrated between 1-3 Hz and were regular in the 1.5 Hz frequency region. CONCLUSIONS: These results prove that the magnetic induction pulse wave can be used to accurately measure pulse wave features.

Application of Minimum Phase Method in a Pulse Measurement

Reconstruction of Electromagnetic Pulse Waveform Based on the Amplitude Spectrum Data

An Iterative Approach for EMI Source Reconstruction Based on Phaseless and Single-Plane Near-Field Scanning

An Amplitude and Phase Recovery Method from Saturated Sinusoidal Signal

A Phaseless Source Reconstruction Method Based on Hybrid Dynamic Differential Evolution with Least Square and Regularization

An Experimental Study of Pulse Wave Measurements with Magnetic Induction Phase Shift Method

A NEW METHOD FOR REAL-TIME DETECTING HARMONICS AND REACTIVE CURRENTS IN SINGLE-PHASE CIRCUIT

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Broadband Radiation Source Reconstruction Based on Phaseless Magnetic Near-Field Scanning

An EM Imaging Method Based on Plane-Wave Spectrum and Transmission Line Model

Reduction of Phase Error Caused by Overexposure in Phase Measurement Profilometry

FM-CW Signal Phase Error Analysis and Compensation

High Accurate Measurement Method on Phase Difference

Phase Error Measurement Algorithm for Sampling System in Power Fault Recorder

Method of Measuring Field Emission Current under High-Voltage Pulse

An Amplitude-Phase Measurement Method for Cross-Eye Jammers

A Phase-Error Immune Approach for Measuring Transport AC Loss by Determination of Minimum Compensated Voltage

Phase Noise Suppression for <italic>φ</italic>-OTDR With Optimized Minima Controlled Recursive Averaging Method

Recovering Amplitudes and Phases from Saturated Multifrequency Sinusoid Signals

A Novel Approach to Measuring EMP Based on Signal Processing Techniques

Analysis on minimum-phase characteristics of measured head-related transfer functions affected by sound source responses