Abstract:It may be a potential way to realize high-efficiency and high-quality local loading forming on the double-action press. However, the deformation characteristics and forming quality of transitional region are the weak link during forming process. In this work, the material flow, deformation inhomogeneity, forming defect of transitional region, and their dependences on the local loading parameters were quantitatively investigated by FE simulation. It is found that due to the constraint clearance, the web material would undergo twice transverse flow with opposite directions successively in two loading steps. This phenomen is basically the same as that in the local loading forming on single-action press, while the extent of transverse material flow on double-action press is greatly smaller. Finally, the transitional region presents different strain distributions in various sub-regions. Region A and region C present a symmetric strain concentration area at rib root, while region B presents a slant strain concentration area at the middle rib. The forming quality on double-action press is better than that on the single-action press. Only a cavum defect at left rib is produced because of the transverse material flow. Constraint clearance plays the most important role in the deformation characteristics and forming quality during the local loading forming on double-action press. The transverse material flow and cavum defect can be suppressed by decreasing the constraint clearance, but the deformation inhomogeneity would increase to some extent at the same time. In addition, the friction factor and radius of left rib are the second significant factors. Increasing the friction factor and radius of left rib is helpful to suppress the transverse material flow and cavum defect, respectively. As far as the forming quality of transitional region is concerned, it is a better way to conduct the local loading forming on double-action press than on single-action press. The results will provide basis for the design of processing parameters in the local loading forming of Ti-alloy rib-web component on double-action press.

Study on the metal flow in power spinning process of parts with transverse inner rib

Exploring Forming Mechanism of a Part with Transverse Inner Rib during Power Spinning

Plastic Deformation Behaviors and Their Application in Power Spinning Process of Conical Parts with Transverse Inner Rib

Forming the Transverse Inner Rib of a Curved Generatrix Part Through Power Spinning

Effects of Material Properties on Power Spinning Process of Parts with Transverse Inner Rib

Multi-pass Spinning of Thin-Walled Tubular Part with Longitudinal Inner Ribs

Rib Filling Behavior in Flow Forming of Thin-Walled Tube with Helical Grid-Stiffened Ribs

Research on the Influence of Ultrasonic on the Inner Rib’s Surface Morphology of Ribbed Cylindrical Parts in Flow Spinning Process

Process factors influencing spinning deformation of thin-walled tubular part with longitudinal inner ribs

Advances in Spinning of Aluminum Alloy Large-sized Thin-walled and Special-curved Surface Head

Formation Mechanism and Control of Flaring in Forward Tube Spinning

Deformation Characteristics of Transitional Region During Local Loading Forming of Ti-alloy Rib-Web Component on the Double-Action Press

Determination of Formability Considering Wrinkling Defect in First-Pass Conventional Spinning with Linear Roller Path

Flow defects of rib-web components in isothermal local-loading forming process

Research on Plastic Deformation Behavior of Double Rollers Clamping Sheet Metal Spinning Process

Analysis on metal flow and deformation mechanism during thickening process of poly-wedge pulley spinning

Influence of process parameters on the degree of inhomogeneous deformation in spinning of complicated thin-walled parts with hoop inner rib

Study of Deformation Mechanism of Backward Ball Spinning of Thin-Walled Tube with Longitudinal Inner Ribs

Study on Cross Section Geometry of Preform for the Forming Laws of A Symmetrical Rib-Web Component

Quantitative Analysis of the Material Flow in Transitional Region During Isothermal Local Loading Forming of Ti-alloy Rib-Web Component

Study on the Ultrasonic-Assisted Spinning of Thin-Walled Cylindrical Parts with Longitudinal and Transverse Ribs