Abstract:Product variation reduction is critical to improve process efficiency and product quality, especially for multistage machining process (MMP). However, due to the variation accumulation and propagation, it becomes quite difficult to predict and reduce product variation for MMP. While the method of statistical process control can be used to control product quality, it is used mainly to monitor the process change rather than to analyze the cause of product variation. In this paper, based on a differential description of the contact kinematics of locators and part surfaces, and the geometric constraints equation defined by the locating scheme, an improved analytical variation propagation model for MMP is presented. In which the influence of both locator position and machining error on part quality is considered while, in traditional model, it usually focuses on datum error and fixture error. Coordinate transformation theory is used to reflect the generation and transmission laws of error in the establishment of the model. The concept of deviation matrix is heavily applied to establish an explicit mapping between the geometric deviation of part and the process error sources. In each machining stage, the part deviation is formulized as three separated components corresponding to three different kinds of error sources, which can be further applied to fault identification and design optimization for complicated machining process. An example part for MMP is given out to validate the effectiveness of the methodology. The experiment results show that the model prediction and the actual measurement match well. This paper provides a method to predict part deviation under the influence of fixture error, datum error and machining error, and it enriches the way of quality prediction for MMP.

Quality Diagnosis and Error Compensation Based on Integrated SPC/EPC in MMPs

Support Vector Machines-Based Method for Machining Error Prediction Modeling

Method of Change Management Based on Dynamic Machining Error Propagation

Design and implementation of an MPC system with model error detection

Quality control in multistage machining processes based on a machining error propagation event-knowledge graph

A Method Of Change Management In Error Analysis For Multistage Machining Processes

Quality Control System for Short-Runs Based on Machining Error Propagation Network

An E-Quality Control Model for Multistage Machining Processes of Workpieces

A change management framework: managing the error variations in multi-stage machining processes

Modeling of Machining Error Propagation Network for Multistage Machining Processes

Modelling of Machining Error Flow Based on Form Features for Multistage Processes.

A Novel Error Compensation Method for Multistage Machining Processes Based on Differential Motion Vector Sets of Multiple Contour Points

Multi-stage error compensation with closed-loop quality control in five-axis flank milling of sculptured surface

Improved Quality Prediction Model for Multistage Machining Process Based on Geometric Constraint Equation

A Kinematics and Experimental Analysis of Form Error Compensation in Ultra-Precision Machining

The Complexity Analysis of A Machining Error Propagation Network and Its Application

An Error Prediction Model of NC Machining Process Considering Multiple Error Sources

The Process Quality Control Method Based on Coupling Machining Sensor Network.

Intelligent Integrated Method of EPC and SPC in Manufacturing Process Quality Control

Study on Machining Error Propagation for Multistage Processes

E-quality Control Architecture for Multistage Machining Processes