Abstract:Product variation reduction is critical to improve process efficiency and product quality, especially for multistage machining process (MMP). However, due to the variation accumulation and propagation, it becomes quite difficult to predict and reduce product variation for MMP. While the method of statistical process control can be used to control product quality, it is used mainly to monitor the process change rather than to analyze the cause of product variation. In this paper, based on a differential description of the contact kinematics of locators and part surfaces, and the geometric constraints equation defined by the locating scheme, an improved analytical variation propagation model for MMP is presented. In which the influence of both locator position and machining error on part quality is considered while, in traditional model, it usually focuses on datum error and fixture error. Coordinate transformation theory is used to reflect the generation and transmission laws of error in the establishment of the model. The concept of deviation matrix is heavily applied to establish an explicit mapping between the geometric deviation of part and the process error sources. In each machining stage, the part deviation is formulized as three separated components corresponding to three different kinds of error sources, which can be further applied to fault identification and design optimization for complicated machining process. An example part for MMP is given out to validate the effectiveness of the methodology. The experiment results show that the model prediction and the actual measurement match well. This paper provides a method to predict part deviation under the influence of fixture error, datum error and machining error, and it enriches the way of quality prediction for MMP.

The Complexity Analysis of A Machining Error Propagation Network and Its Application

Modeling of Machining Error Propagation Network for Multistage Machining Processes

Complexity Analysis of Distributed Measuring and Sensing Network in Multistage Machining Processes

Method of Change Management Based on Dynamic Machining Error Propagation

An Extended Machining Error Propagation Network Model for Small-Batch Machining Process Control of Aircraft Landing Gear Parts

Study on Machining Error Propagation for Multistage Processes

Modelling of Machining Error Flow Based on Form Features for Multistage Processes.

Quality Control System for Short-Runs Based on Machining Error Propagation Network

Quality control in multistage machining processes based on a machining error propagation event-knowledge graph

The Error Fluctuation Evaluation For Key Machining Form Feature Of High-Value Difficult-To-Cut Part

Multistage Machining Processes Variation Propagation Analysis Based on Machining Processes Weighted Network Performance

Quality Diagnosis and Error Compensation Based on Integrated SPC/EPC in MMPs

A Method Of Change Management In Error Analysis For Multistage Machining Processes

Research on Identification of Critical Quality Features of Machining Processes Based on Complex Networks and Entropy-CRITIC Methods

A Comprehensive Evaluation Method of Machining Center Components' Importance Based on Combined Variable Weight

A Method For Identifying Error Sources In Complex Assembly Process Based On Multi-Level Network

The Process Quality Control Method Based on Coupling Machining Sensor Network.

An Error Prediction Model of NC Machining Process Considering Multiple Error Sources

A point-based variation propagation model for multi-pass machining process

Improved Quality Prediction Model for Multistage Machining Process Based on Geometric Constraint Equation

A novel framework for the reliability modelling of repairable multistate complex mechanical systems considering propagation relationships.