Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Analysis of Entrance Converging Flow of Polymer Melts. A Comparison Between Liang Model and Cogswell Model

Close-contact Melting of Shear-Thinning Fluids

Can the Numerical Simulations of Melting in a Differentially-Heated Rectangular Cavity Be Rationally Reduced to 2D? A Comparative Study Between 2D and 3D Simulation Results

Numerical simulation of filling flow of polymer melt in injection molding

Simulations of Interaction Between Flow and a Thin Elastic Beam Using Cip-Based Model with Adaptive Mesh

Numerical Investigation on Local Non-equilibrium Flows Using a Diatomic Nonlinear Constitutive Model

Modeling the Chain Conformation of Polymer Melts in Contraction Flow

Flows of polymer melts through nanopores: Experiments and modelling

Modelling Slip Flow in Micro/nano Gaps with Moving Boundary

Numerical Simulation of the Melting of Solid Particles in Thermal Convection with a Modified Immersed Boundary Method

Equal Low-Order Finite Element Simulation of the Planar Contraction Flow for Branched Polymer Melts

Numerical Simulation And Research On The Electroosmotic Flow In The Curve Channel

COUPLING SIMULATION MODEL OF MELT FLOW AND FIBER ORIENTATION FOR FIBER REINFORCED PLASTICS IN INJECTION MOLDING

Numerical simulation of polymeric flow based on molecular models

Study on Simulation of Molten Polymer Flow in the Screw Groove

SIMULATION OF AXISYMMETRIC CONTRACTION FLOW FOR POLYMER MELT BY USING PSM MODEL

Numerical Simulation of Flow Distribution of Polymer Melt in a Linearly Tapered Coat-hanger Die

Numerical Simulation and Experimental Verification of the Filling Stage in Injection Molding

Analysis of 1 + 1 Dimensional Stochastic Models of Liquid Crystal Polymer Flows

NUMERICAL SIMULATION OF NON-ISOTHERMAL PLANAR CONTRACTION FLOW OF POLYMER MELTS

Contour-Variable Model of Constitutive Equations for Polymer Melts