Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

Modeling the Chain Conformation of Polymer Melts in Contraction Flow

Conformations and Migration Behaviors of Confined Semiflexible Polymers under Poiseuille Flow

Mechanical Behaviors of Copolymer Elastomers: Experimental Characterization and Constitutive Modelling

Constitutive Equations of Non-Isothermal Polymer Melt

Multi-scale mathematic modeling of non-isothermal polymeric flow of fiber suspensions

Contour-Variable Model of Constitutive Equations for Polymer Melts

Equal Low-Order Finite Element Simulation of the Planar Contraction Flow for Branched Polymer Melts

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Numerical Simulation of the Non-isothermal Viscoelastic Flow Past a Confined Cylinder

Molecular configuration evolution model and simulation for polymer melts using a non-equilibrium irreversible thermodynamics method

Self-Consistent Connected-Rod Model for Small-Angle Scattering from Deformed Semiflexible Chains in Flow

A numerical study of constitutive models endowed with Pom-Pom molecular attributes

Nonaffine Network Structural Model of Molten High Polymer and Its Numerical Analyzes

Molecular Dynamics Simulations Informed Hyperelastic Constitutive Model with Insights into Entangled Free Chains

A single-mode rheological model for steady flows of polymer melts

Extensional flow of bulk polymers studied by dynamic Monte Carlo simulations

Analysis of Entrance Converging Flow of Polymer Melts. A Comparison Between Liang Model and Cogswell Model

An Experimental Investigation of Viscoelastic Flow in a Contraction Channel

NUMERICAL SIMULATION OF NON-ISOTHERMAL PLANAR CONTRACTION FLOW OF POLYMER MELTS

NONAFFINE NETWORK STRUCTURAL MODEL OF MOLTEN HIGH POLYMER IN SINUSOIDAL STRAIN FIELD

A Mean-Field Shear Transformation Zone Theory for Amorphous Polymers