Abstract:This study aims at establishing a model for close-contact melting (CCM) of shear-thinning fluids. We presented a theoretical framework for predicting the variation of liquid melt film thickness and motion of unmelted solid for both Carreau and power-law fluids. We identified the appropriate energy equation considering the convective effect and derived an analytical temperature profile across the liquid film. Using the lubrication approximation, force equilibrium relationships and the corresponding numerical approaches were built. By using laser interferometry and photographic recording methods, we found excellent agreement between numerical solutions and experimental results for Carreau liquids, revealing that the convective effect weakens heat transfer and melting rate. We identified the critical liquid film thickness that determines three situations of CCM in the theoretical model for Carreau fluids. Numerical prediction demonstrated that the CCM of Carreau fluids can be almost equivalent to that of power-law fluids if the initial film thickness is greater than the critical value. Finally, approximate analytical models were developed for both Carreau and power-law models. For the applicability of the approximate analytical solutions, we derived two-and three-dimensional dimensionless phase diagrams of validity range and identified a key dimensionless group (?Re)Re-4/3 [3 ln(Ste + 1)](1/3) Pe(-1/3), where ? is dimensionless characteristic time, Re is Reynolds number, Ste is Stefan number and Pe is Peclect number. The reliability of the approximate solutions was verified by comparing with the numerical results. These approximate solutions enable convenient and low-cost computational prediction of the dynamic CCM process of shear-thinning fluids.

Numerical Simulation of Flow Distribution of Polymer Melt in a Linearly Tapered Coat-hanger Die

Numerical simulation of filling flow of polymer melt in injection molding

Close-contact Melting of Shear-Thinning Fluids

Numerical prediction of effect of filling flow on short fiber orientation in injection molding

Numerical Investigation of Hydrodynamics and Heat Transfer for Bingham-pseudoplastic Fluids in an Industrial Coiled Stirred Tank

Numerical Simulation of Coat-Hanger Die Filled with Cores of Different Angles

Study on Simulation of Molten Polymer Flow in the Screw Groove

Numerical Simulation and Analysis of the Effect of Some Materials and Processing Parameters on the Gas Assisted Extrusion of Ultra-high Molecular Weight Polyethylene

3D Numerical Simulation of Temperature Field Coupled with Flow Field of the Liquid Metal in Shot Sleeve of Die Casting Process

Dimensional Analysis Theory and Molecular Dynamics Simulation of Polypropylene Melt Flow during Injection Molding Process

3D Flow Simulation for Viscous Nonisothermal Incompressible Fluid in Injection Molding

Quasi-1D Modeling of Polymer Melt Die Swell in Short Dies

Energy analysis of the extrusion process through a streamlined Gaussian die

Integrated Simulation of Fluid Flow and Heat Transfer in Injection Molding for the Prediction of Shrinkage and Warpage

Numerical Simulation and Experimental Validation of Liquid‐film‐flow Characteristics in Dip Coating for Non‐newtonian Fluids

Numerical simulation of polymeric flow based on molecular models

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Modeling and simulation for varying die gap fluid extrusion

Numerical Study of Heat Transfer and Temperature in the Screw Groove for Molten Plastic

NUMERICAL METHOD OF PACKING ANALYSIS IN INJECTION MOLDING OF POLYMERS

Numerical Simulation on the Liquid Metal Flow of the Acceleration Phase in the Shot Sleeve of Cold Chamber Die Casting Process