Abstract:The three-dimensional (3D) viscoelastic polymer melt filling process in injection molding has always been regarded as a challenging two-phase flow problem. Numerical investigations concerning it are very limited, especially under the non-isothermal condition. Thus, this article presents a 3D non-isothermal two-phase model to investigate the flow-induced stresses during the viscoelastic fluid filling process. The viscoelastic behavior of polymer melt is predicted by the eXtended Pom-Pom (XPP) model, in which the temperature dependence of polymeric viscosity and relaxation times are described using the Arrhenius equation. The 3D governing equations are solved by a collocated finite volume method. The high resolution revised level set method coupled with a domain extension technique is extended to capture the 3D melt front interface in an irregular cavity. The collocated finite volume method and the revised level set solver are respectively validated using the XPP melts past a cylinder and the single vortex flow. Then the ability of the presented 3D two-phase model is verified by the isothermal Newtonian fluid filling process in a thin rectangular cavity. The numerical results are in good agreement with those reported in literature. Finally, the challenging problem of non-isothermal XPP fluid filling process in a 3D rectangular cavity with one cylindrical insert is investigated. The temperature field, flow-induced stresses and the corresponding rheological behaviors of polymer melt during 3D filling process are quantitatively predicted. Especially, the effects of processing conditions and energy source term on the two normal stress differences are discussed. It is found that melt temperature and injection velocity are the main factors that affect the normal stress differences. The obtained results should be helpful for improving the product properties in practical production. (C) 2016 Elsevier Ltd. All rights reserved.

NUMERICAL SIMULATION OF NON-ISOTHERMAL PLANAR CONTRACTION FLOW OF POLYMER MELTS

Numerical simulation of filling flow of polymer melt in injection molding

Finite Volume Method of the Microfiltration of Viscoelastic Polymer Solution

Numerical Simulation of the Non-isothermal Viscoelastic Flow Past a Confined Cylinder

Three-Dimensional Simulation Of Planar Contraction Viscoelastic Flow By Penalty Finite Element Method

Finite Element Simulation of Three-Dimensional Viscoelastic Planar Contraction Flow with Multi-Mode Fene-P Constitutive Model

Non-isothermal Comprehensive 3-D Simulation on Polymer Melt

Three-dimensional Simulations of Non-Isothermal Transient Flow and Flow-Induced Stresses During the Viscoelastic Fluid Filling Process

Equal Low-Order Finite Element Simulation of the Planar Contraction Flow for Branched Polymer Melts

Numerical Simulation of Non-Isothermal Viscoelastic Fluid in the Planner Contraction

Finite Element Simulation of Polymer Melt Flow in Extrusion Molding Processes

Simulations of a Full Three‐dimensional Packing Process and Flow‐induced Stresses in Injection Molding

Modeling and Simulation of Three-Dimensional Planar Contraction Flow of Viscoelastic Fluids with PTT, Giesekus and FENE-P Constitutive Models.

Simulation of Non-isothermal Injection Molding for a Non-Newtonian Fluid by Level Set Method

Numerical Simulation of Flow-Induced Stresses in Mold Filling Process Using a Three-Dimensional Two-Phase Flow Model

Constitutive Equations of Non-Isothermal Polymer Melt

Multi-scale mathematic modeling of non-isothermal polymeric flow of fiber suspensions

Numerical Simulation of Melt Filling and Gas Penetration in Gas Assisted Injection Molding

Numerical Simulation of Three‐dimensional Polymer Extrusion Flow with Differential Viscoelastic Model

Microstructures of Polymer Solutions of Flow Past a Confined Cylinder

Modeling the Chain Conformation of Polymer Melts in Contraction Flow