Abstract:A numerical model for determination the gear tooth root fatigue behaviour is presented. Two cases are being explored, first in which gear tooth was loaded with normal pulsating force acting at the highest point of single tooth contact, and second in which the fact that in actual gear operation the magnitude as well as the position of the force changes as the gear rotates through the mesh is taken into account. The fatigue process leading to tooth breakage is divided into crack initiation and crack propagation period. The critical plane damage model has been used to determine the number of stress cycles required for the fatigue crack initiation. The critical plane methods predict not only fatigue crack initiation life, but also the initiated crack direction, which makes a good starting point for further fatigue crack propagation studies. Finite element method and linear elastic fracture mechanics theories are then used for the further simulation of the fatigue crack growth under a moving load. Moving load produces a non-proportional load history in a gear's tooth root. Consequently, the maximum tangential stress theory will predict a unique kink angle for each load increment, but herein crack’ s trajectory is computed at the end of the load cycle. An approach that accounts for fatigue crack closure effects is developed to propagate crack under non-proportional load. The total number of stress cycles for the final failure to occur is then a sum of stress cycles required for the fatigue crack initiation and number of loading cycles for crack propagation from the initial to the critical length. Although some influences (non-homogeneous material, traveling of dislocations, etc.) were not taken into account in the computational simulations, the presented model seems to be very suitable for determination of service life of gears because numerical procedures used here are much faster and cheaper if compared with the experimental testing.

Mechanisms of Synchronous Belt Tooth Failure Due to Fatigue Shear Fracture

Analysis of Tooth Root Crack Initiation, Propagation and Fracture Surface Based on Gear Bending Fatigue Test

Stiffness Modeling of Tooth Interior Fatigue and Tooth Flank Fracture and Their Fault Characteristics in Electromechanical Coupling Systems

Dynamic Characteristics of Gear System Under Compound Fault of Tooth Root Crack and Bearing Outer Ring

The Tooth Profile of Car Synchronous Belt Influencing on the Stress Distribution

A Cohesive Model-Based Nonlinear Discontinuous Deformation Analysis for Tensile Fracture in Geotechnical Materials

Stress Analysis and Assessment of Stream Setting Vessel Based on Elastic Contact Element Method

Component Structural Equivalent Research Based on Different Failure Strength Criterions and the Theory of Critical Distance

Damage mechanisms of spline teeth of friction plates under non-uniform impact

Gear Tooth Root Fatigue Behaviour

Conveyor belt structure of belt dryer: Analysis and optimization

Loaded Tooth Contact Analysis and Meshing Stiffness Calculation for Cracked Spiral Bevel Gears

Gear Tooth Root Crack Path and Fatigue Life

Failure analysis of composite pre-tightened teeth joints under bending and tension coupling load

Coupling failure dynamics of tooth surface morphology and wear based on fractal theory

An Experimental Study on the Accuracy of Cumulative Damage Models in Gear Tooth Bending Fatigue

An Efficient Multi-Scale Method for Failure Mechanism Analysis of SiCf/Ti Composites with Experimental Validation

Designing the Cross-Linked Network to Tailor the Mechanical Fracture of Elastomeric Polymer Materials

Fracture failure analysis of the teeth of conjunction gear made of 20MnCr5S steel

The Finite Element Analysis of Double Helical Synchronous Belt based on ANSYS

Application of the Thin Slice Model for Determination of Face Load Distribution along the Line of Contact and the Relative Load Distribution Measured along Gear Root