Abstract:BackgroundIn the existing studies, the hysteretic model of tensioner is applied in analysis of a belt drive system which can improve the computational accuracy. But the computational efficiency is low and not suitable for system optimization.PurposeIn this paper, an approach is presented to simplify the tensioner’s hysteretic model into an equivalent stiffness and damping which is used for improving the computational efficiency of vibration responses of the belt drive system.MethodA simplified model and computation method of a belt drive system is established. The hysteretic model of a belt tensioner consists of a linear stiffness and viscous damping based on the averaging energy method to simplify the hysteretic parameters and improve the computational efficiency. The equivalent linear stiffness and damping of the tensioner are estimated using an iterative technique. A timing belt drive system is considered as a case study. The belt system's vibration responses are obtained and compared with the measured results to evaluate the performance of the presented approach.Results and conclusionThe computational results are compared with a previously published method, and the difference between the proposed method (Method I) and the previously published method (Method II) is discussed. The presented method has the following merits: (1) The linearization of tensioner’s hysteretic model can improve the computational efficiency greatly with an acceptable computational accuracy. (2) The semi-analytic method which is used to derive the system equations can further reduce the amount of computation. It is suitable for parameter optimization of system.

The Tooth Profile of Car Synchronous Belt Influencing on the Stress Distribution

Simulation Analysis of Synchronous Belt Transverse Vibration Frequency

Modeling and Simulation Technology of Complex Mechanical Systems

Research on the Arc-Teeth Synchronous Belt's Tooth Load Distribution Caused by the Machining Error

Research on the Tension Effects on Automobile Damping Synchronous Belt Transmission System Damping and Dynamic Stiffness

Analysis and research of dynamic characteristics of synchronous belt of a diesel using multi-body dynamics

The Study of Arc Teethed Automotive Synchronous Belt's Transmission Stability

Dynamic performance simulation research of dual overhead synchronous belt drive system

Solid Modeling And Finite Element Analysis Of Harmonic Drive With Wide Slot Involute Tooth Profile

Measurement and Computational Methods for Rotational Vibration Analysis in Engine Front End Accessory Drive System

Analysis and Simulation on Dynamic Stress of Tracked Vehicle Sprocket Based on Rigid-Flexible Coupling

Dynamics modeling and simulation of steel cord conveyor belt based on dynamic elastic modulus

Spur Gears Static and Dynamic Meshing Simulation and Tooth Stress Calculation

Deformation of Harmonic Drive in Transmission State Based on Contact Analysis with Shell Element Tooth

Effect of Rubber Material Properties on Steady-State Flat Belt Response

Modeling and Simulation for a Corrugating Machine System Based on Flexible Multibody Dynamics

Theoretical and Experimental Study on Contact Characteristics of Spiral Bevel Gears under Quasi-Static and Large Loading Conditions

Non-Linear Analysis Of Elastic Quality For Belt Drives

Multi-Condition Contact Stress Analysis of High Speed Train Helical Gear

Dynamic Modeling of the Belt Drive System with an Equivalent Tensioner Model

An improved dynamic model of spur gear transmission considering coupling effect between gear neighboring teeth