Abstract:As wind turbines become larger and move into deeper sea, their operating environment is getting more and more harsh, which puts higher stability requirements of the transmission chain. The mechanical-hydraulic hybrid transmission (MHHT) combines mechanical and hydraulic systems to improve transmission stability. However, the related research is still in the stage of mechanism verification. In this paper, a 19-degree-of-freedom pure torsion model has been established to study the internal characteristics of the MHHT chain. The model contains parallel gearing, planetary gearing and closed hydraulic transmission simultaneously. The correctness of the modelling method was verified by a software model. The frequency characteristics of the hybrid transmission chain were summarized. The first two modes at different motor displacements were classified as “mechanical mode” and “hydraulic mode” based on the mode shapes. A hydraulic damping model was built based on the leakage of the hydraulic system. The influence of the hydraulic system on the MHHT damping characteristics has been discussed in detail with and without considering the mechanical damping. Finally, a damping compensation method by adjusting the hydraulic motor displacement was proposed. The control algorithm was derived by a simplified model and verified by the 19-degree-of-freedom pure torsion model. The simulation results under different working conditions show that this method can effectively reduce the first-mode torsional vibration and improve the life of the drivetrain.

The Study of Arc Teethed Automotive Synchronous Belt's Transmission Stability

Simulation of nonlinear vibration of automobile main reducer

Study on Electromechanical Coupling Characteristics of Electric Vibration Table in High-Translational-Acceleration

Simulation Analysis of Synchronous Belt Transverse Vibration Frequency

Control method of multi-motor's speed synchronization control in dynamometer test bench for multi-axles'vehicle

Research on the Tension Effects on Automobile Damping Synchronous Belt Transmission System Damping and Dynamic Stiffness

Effect of Shaft Misalignment on Time-varying Mesh Model of Spur Gear

Comprehensive Dynamic Model and Vibration Characteristics of Step-Type Compound Planetary Gear Sets

The Tooth Profile of Car Synchronous Belt Influencing on the Stress Distribution

Automotive Synchronous Belt Transmission Stationarity Simulation Analysis Based on the Rigid-Flexible Coupling

Research on Transmission Characteristics and Torsional Vibration Control of Hybrid Transmission Wind Turbines

Vibration Analysis of Main Transmission System of the Bar Mills

Measurement and Computational Methods for Rotational Vibration Analysis in Engine Front End Accessory Drive System

Reliability Optimization Design of Transmission Mechanism of Automotive Mechanical Transmission Based on Feature Extraction

Nonlinear stability of synchronous transmission in vibration system

Research on the Arc-Teeth Synchronous Belt's Tooth Load Distribution Caused by the Machining Error

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Influence of electrical part of traction transmission on dynamic characteristics of railway vehicles based on electromechanical coupling model

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Research on coupled vibrations of driveshaft–rear axle system based on nonlinear hybrid model

Coupled vibrations of a drive system during automatic transmission