Abstract:Traditional adobe masonry wall is made of natural soil, sand, fiber materials without artificial hydraulic binders such as cement, lime and etc. It has been wildly used in residential buildings all over the world for thousands of years. This paper mainly aims at obtaining an insight on the seismic performance of traditional adobe walls subjected to in-plane cyclic loading. Consequently, five 1/2-scale specimens were tested under various levels of vertical stress and height/length ratios. The test results showed that three failure modes including flexural cracking/diagonal shear, rocking/toe crushing/bed joint sliding and rocking/bed joint sliding were observed to be showing horizontal and stair-stepped cracks on the interfaces between block and mortar. The failure mechanism, crack patterns and force–displacement responses were summarized and found to be similar to those of URM walls. However, significant residual displacements under each cyclic loading improved the drift limit and energy-dissipation capacity greatly. The mean value of ultimate linear and peak drift were 0.37 and 1.07 % which were about 3 and 4.5 times greater than those of URM wall. Moreover, the displacement ductility was improved. The values of equivalent viscous damping ratio varied from 0.1 to 0.3 with drift. The damping ratio values were significantly higher than those of URM, and almost equal to those of reinforced masonry walls failing in flexure. Based on test results above, it can be concluded that although lateral force resistance was weaker the deformation resistance and energy-dissipation capacity were higher than those of URM wall.

Mechanical Properties of Adobe Masonry in Shear Test

Strength and stress–strain characteristics of traditional adobe block and masonry

Seismic Performance of Traditional Adobe Masonry Walls Subjected to In-Plane Cyclic Loading

Experimental Study on Shear Strength of Mortar Joint of Dry-Laid Stone Masonry Walls

EXPERIMENTAL RESEARCH ON SHEAR BEHAVIOR OF STONE MASONRY JOINT UNDER SHEAR AND COMPRESSION LOADING

Study on the shear properties of masonry pagoda mortar and its influencing factors

Experimental Study on Shear Behavior of Autoclaved Fly Ash Brick Masonry

Experimental Study of Traditional Adobe Block Compressive Strength

In-Plane Cyclic Behaviour Comparison of Adobe Wall Retrofitted by Mortar Enhanced by Physical and Chemical Methods

Direct Shear Test and Shear Strength Model of Clay-Filled Joints

Study on Shear Behavior of Stone Masonry Joints Strengthened with Polymer Mortar

Experimental and Numerical Analysis of the Compressive and Shear Behavior for a New Type of Self-Insulating Concrete Masonry System

Analysis of the Shear Failure Process of Masonry by Means of A Meso-Scopic Mechanical Modeling Approach

Experimental Research on Shear Performance of Reinforced Block Short-Leg Masonry Shear Wall

Effects of Shear Rate on Cyclic Behavior of Dry Stack Masonry Joint

Research on reinforced block short-leg masonry shear wall

In-Plane Shear Behavior of Unreinforced Masonry Wall Strengthened with Bamboo Fiber Textile-Reinforced Geopolymer Mortar

The Effects of Applied Axial Stress on Lateral Bearing-Load Capacity for Fully Grouted Reinforced Concrete Masonry Shear Walls

Experimental Study of Mechanical Properties of Small-sized Hollow Fly-ash Confined Masonry

RESEARCH ON THE SEISMIC BEHAVIOR OF THE REINFORCED BLOCK SHORT-LEG MASONRY SHEAR WALL

Bonding Behavior of Cement Mortar Retrofitting for Adobe Masonry Wallette with Groove, Wire Mesh, Shear Dowel, and Sticky Rice Paste