Abstract:Due to the continued increasing levels of CO2 emissions that is contributing to climate change, CO2 mitigation technologies, particularly carbon capture and storage, are being developed to address the goal of abating CO2 levels. Carbon capture technologies can be applied at the pre-combustion, oxy-fuel combustion, and post-combustion stages, the latter being the most widely used due to its flexibility. Among the several CO2 separation processes available for carbon capture, absorption is the most widely used where amine solutions are used as absorbents. This paper highlights the use of a wetted wall column fabricated by Siy and Villanueva (2012) and simulated flue gas to determine the performance of CO2 absorption in terms of the percentage of CO2 absorbed, the steady state time, and the overall gas mass transfer coefficient. The concentrations used were 1, 5, 10, and 15% NH3(aq) at a constant temperature range of 12-17oC, solvent flow rate of 100 mL/min, and simulated flue gas flow rate of 2 L/min. It was found that increasing the solvent concentration resulted in a proportional increase both in the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The average percentage of CO2 absorbed ranged within 52.25% to 95.29% while the overall mass transfer coefficient ranged from 0.1843 to 0.7746 mmol/m2∙s∙kPa. However, erratic behavior was seen for the time required for the system to reach steady state. Using Design ExpertTM for analysis, the results showed that the effect of varying the concentration had a significant effect on the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The results proved that the greater the aqueous ammonia concentration, the greater the percentage of CO2 absorbed. The range of 5-10% aqueous ammonia is recommended because the percentage of CO2 absorbed peaks at an average of 92% beyond the range of 5-10%.

Comparison of Removal Efficiencies of Carbon Dioxide Between Aqueous Ammonia and NaOH Solution in a Fine Spray Column

Experimental Studies on Removal Capacity of Carbon Dioxide by a Packed Reactor and a Spray Column Using Aqueous Ammonia

Experimental Studies on Removal of Carbon Dioxide by Aqueous Ammonia Fine Spray

Comparison of Capture Efficiencies of Carbon Dioxide by Fine Spray of Aqueous Ammonia and MEA Solution

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

The Absorption Rates of CO2 by Aqueous Ammonia Solution in a Spray Column

Volumetric Overall Mass Transfer Coefficients of CO_2 Absorption Into Aqueous Ammonia of Fine Spray

Experimental Study on Absorption of Carbon Dioxide in Flue Gas by Monoethanolamine Fine Spray

Experimental Study on Co2 Absorption by Aqueous Ammonia Solution at Elevated Pressure to Enhance Co2 Absorption and Suppress Ammonia Vaporization

Experimental studies on CO2 capture in a spray scrubber using NaOH solution

The Absorption Rate of CO2 by Aqueous Ammonia in a Packed Column

Reaction Sensitivity Analysis of CO2 Absorption Using Aqueous Ammonia in a Packed Column

Experimental Studies on Carbon Dioxide Desorption from Carbonated Ammonia Solution in a Packed Column

Carbon Dioxide Absorption in a Fabricated Wetted-Wall Column Using Varying Concentrations of Aqueous Ammonia

Absorption of carbon dioxide in aqueous ammonia

Mass Transfer Coefficients for CO2 Absorption into Aqueous Ammonia Solution Using a Packed Column

Research Progress of Aqueous Amine Solution for CO2 Capture: A Review

Carbon dioxide absorption by Ammonia-promoted aqueous triethanolamine solution in a packed bed

Experimental Studies on Suppression of Ammonia Vaporization by Additives

Effect of Operating Conditions on Co Absorption into Aqueous Alkanol amine Solutions in Packed Column