Abstract:Due to the continued increasing levels of CO2 emissions that is contributing to climate change, CO2 mitigation technologies, particularly carbon capture and storage, are being developed to address the goal of abating CO2 levels. Carbon capture technologies can be applied at the pre-combustion, oxy-fuel combustion, and post-combustion stages, the latter being the most widely used due to its flexibility. Among the several CO2 separation processes available for carbon capture, absorption is the most widely used where amine solutions are used as absorbents. This paper highlights the use of a wetted wall column fabricated by Siy and Villanueva (2012) and simulated flue gas to determine the performance of CO2 absorption in terms of the percentage of CO2 absorbed, the steady state time, and the overall gas mass transfer coefficient. The concentrations used were 1, 5, 10, and 15% NH3(aq) at a constant temperature range of 12-17oC, solvent flow rate of 100 mL/min, and simulated flue gas flow rate of 2 L/min. It was found that increasing the solvent concentration resulted in a proportional increase both in the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The average percentage of CO2 absorbed ranged within 52.25% to 95.29% while the overall mass transfer coefficient ranged from 0.1843 to 0.7746 mmol/m2∙s∙kPa. However, erratic behavior was seen for the time required for the system to reach steady state. Using Design ExpertTM for analysis, the results showed that the effect of varying the concentration had a significant effect on the percentage of CO2 absorbed and the overall gas mass transfer coefficient. The results proved that the greater the aqueous ammonia concentration, the greater the percentage of CO2 absorbed. The range of 5-10% aqueous ammonia is recommended because the percentage of CO2 absorbed peaks at an average of 92% beyond the range of 5-10%.

The Absorption Rate of CO2 by Aqueous Ammonia in a Packed Column

Mass Transfer Coefficients for CO2 Absorption into Aqueous Ammonia Solution Using a Packed Column

The Absorption Rates of CO2 by Aqueous Ammonia Solution in a Spray Column

Experimental Studies on Removal Capacity of Carbon Dioxide by a Packed Reactor and a Spray Column Using Aqueous Ammonia

Volumetric Overall Mass Transfer Coefficients of CO_2 Absorption Into Aqueous Ammonia of Fine Spray

Effect of Operating Conditions on Co Absorption into Aqueous Alkanol amine Solutions in Packed Column

Reaction Sensitivity Analysis of CO2 Absorption Using Aqueous Ammonia in a Packed Column

Absorption of carbon dioxide in aqueous ammonia

Experimental Study on Co2 Absorption by Aqueous Ammonia Solution at Elevated Pressure to Enhance Co2 Absorption and Suppress Ammonia Vaporization

Experimental Study on Carbon Dioxide Absorption by Aqueous Ammonia with Nickel and Chromium Ions in Bubbling Tower at Low Temperatures

[Experimental Study on CO2 Absorption by Aqueous Ammonia-Based Blended Absorbent].

Carbon dioxide absorption by Ammonia-promoted aqueous triethanolamine solution in a packed bed

Experimental Studies on Carbon Dioxide Desorption from Carbonated Ammonia Solution in a Packed Column

Research Progress on the Mass Transfer Process of CO2 Absorption by Amines in a Packed Column

Experimental Studies And Rate-Based Process Simulations Of Co2 Absorption With Aqueous Ammonia Solutions

Kinetics of CO2 Absorption in Aqueous Ammonia Solution

Carbon Dioxide Absorption in a Fabricated Wetted-Wall Column Using Varying Concentrations of Aqueous Ammonia

Study on Mass Transfer and Kinetics of CO2 Absorption into Aqueous Ammonia and Piperazine Blended Solutions

Kinetics and mass transfer of carbon dioxide absorption into aqueous ammonia

Semi-batch experimental study on CO2 absorption characteristic of aqueous ammonia

Rate-Based Modeling of CO2 Absorption in Aqueous NH3 in a Packed Column