Abstract:With increasing trends in using municipal waste incineration (MWI) technologies, more consideration has been given to the problem of harmful byproducts in its flue. In 2014, a new national standard for pollution control of municipal solid waste incineration was released by the Chinese government, which also gives guidance to local governments to establish their own standards. In order to evaluate whether the treatment technologies for MWI flue gas can both meet the new standard and have overall positive environmental impacts across whole life cycle, a waste life cycle assessment (LCA) was conducted for flue gas to compare treatment technologies employed in MWI plants. Based on a case study of a plant in Changzhou China, a model was established using three combinations of technologies: (a) Spray semi dry reactor + activated carbon + filter bag (Scenario 1); (b) Spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 2); (c) selective non-catalytic reduction (SNCR) + spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 3). The study has wide policy implications on how the industry is, or should be, regulated. Normalized results revealed that technologies used in Scenarios 1 and 2 had less overall impacts on the environment and less direct impact from emissions than those of Scenario 3. Energy-conservation and emission reduction index showed that Scenario 2 best fits current conditions and policy goals about energy consumption and air pollutant emission, despite recent regulations for the requirement of including SNCR in incineration plants. The most significant limiting factor is NON, which is in alignment with the results of policy analysis. Integrated analysis showed that although Scenario 2 is the best choice under current circumstances, further improvement in technology are likely to meet with new standards. Policy-makers should comprehensively consider the environmental impacts of the entire life cycle instead of the one-size-fits all standard.(C) 2018 Elsevier Ltd. All rights reserved.

Research and application of wastes fluidized bed incineration technology at Zhejiang University

Feasibility Study of Municipal Solid Wastes Incineration Power Generation in Jinhua

Integrated modeling of bed temperature for a circulating fluidized bed incinerator

A Brief Report on Research Progress of Combined Grate-circulating Fluidized Bed incinerator

Biomass Utilization As A Clean Energy In Zhejiang University

Industrial hazardous waste treatment featuring a rotary kiln and grate furnace incinerator: a case study in China

Experimental Research of Pipe-Distributed MSW Fluidized Bed Incinerator

Proceedings of International Thermal Treatment Technologies ( IT 3 ) , San Antonio , TX , October 2013 A Rapidly Emerging WTE Technology : Circulating Fluid Bed Combustion

Application of microwave heating in disposal and utilization of MSW fly ash

Investigation on Particle Mixing Characteristics of Municipal Solid Wastes Fluidized Bed Incinerator

Study On Sewage Sludge Fluidized Bed Incineration And Design Of 65t/D Incinerator

Status and Development of Sludge Incineration in China

Evaluation of Flue-Gas Treatment Technologies for Municipal Waste Incineration: A Case Study in Changzhou, China

Analysis of composition characteristics and treatment techniques of municipal solid waste incineration fly ash in China

Application and Development of Washary Tailings Fluidized Bed Combustion Technology

Experimental Study on Municipal Solid Waste Incineration with 1MW CFBI

Investigation of Novel Incineration Technology for Hospital Waste.

Liquid Hazardous Wastes Incineration

Bioferment residue: TG-FTIR study and cocombustion in a MSW incineration plant.

Research and development of integrative treatment system of municipal solid waste and its key techniques

Recent progress on the thermal treatment and resource utilization technologies of municipal waste incineration fly ash: A review