Abstract:With increasing trends in using municipal waste incineration (MWI) technologies, more consideration has been given to the problem of harmful byproducts in its flue. In 2014, a new national standard for pollution control of municipal solid waste incineration was released by the Chinese government, which also gives guidance to local governments to establish their own standards. In order to evaluate whether the treatment technologies for MWI flue gas can both meet the new standard and have overall positive environmental impacts across whole life cycle, a waste life cycle assessment (LCA) was conducted for flue gas to compare treatment technologies employed in MWI plants. Based on a case study of a plant in Changzhou China, a model was established using three combinations of technologies: (a) Spray semi dry reactor + activated carbon + filter bag (Scenario 1); (b) Spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 2); (c) selective non-catalytic reduction (SNCR) + spray semi dry reactor + dry deacidification reactor + activated carbon + filter bag (Scenario 3). The study has wide policy implications on how the industry is, or should be, regulated. Normalized results revealed that technologies used in Scenarios 1 and 2 had less overall impacts on the environment and less direct impact from emissions than those of Scenario 3. Energy-conservation and emission reduction index showed that Scenario 2 best fits current conditions and policy goals about energy consumption and air pollutant emission, despite recent regulations for the requirement of including SNCR in incineration plants. The most significant limiting factor is NON, which is in alignment with the results of policy analysis. Integrated analysis showed that although Scenario 2 is the best choice under current circumstances, further improvement in technology are likely to meet with new standards. Policy-makers should comprehensively consider the environmental impacts of the entire life cycle instead of the one-size-fits all standard.(C) 2018 Elsevier Ltd. All rights reserved.

A Brief Report on Research Progress of Combined Grate-circulating Fluidized Bed incinerator

Feasibility Study of Municipal Solid Wastes Incineration Power Generation in Jinhua

Emission characteristics of sludge incineration in bubbling fluidized bed

Experimental Research of Pipe-Distributed MSW Fluidized Bed Incinerator

The Experiment Research On Original Pollutant Emission From Grate And Fluidized Bed Incinerator Fired Msw

Research and application of wastes fluidized bed incineration technology at Zhejiang University

Comparison of Two Types of Municipal Solid Wastes Incineration

Validation of Municipal Sludge Incineration in Circulation Fluidized Bed Boiler from a Thermal Power Plant

Experimental Study on Municipal Solid Waste Incineration with 1MW CFBI

Municipal Sewage Sludge Incineration and Its Air Pollution Control

Status and Development of Sludge Incineration in China

Evaluation of Flue-Gas Treatment Technologies for Municipal Waste Incineration: A Case Study in Changzhou, China

Heat Transfer in a Municipal Solid Waste Incinerator

Life Cycle Assessment of Advanced Circulating Fluidized Bed Municipal Solid Waste Incineration System from an Environmental and Exergetic Perspective

Study on Drying and Combustion Process in Grate-Cfb Incinerator

Investigation on Particle Mixing Characteristics of Municipal Solid Wastes Fluidized Bed Incinerator

Distribution of PCDD/F and PCB at Different Positions of Circulating Fluidized Bed Municipal Solid Waste Incinerators

Current Status of Technology and Standards of domestic Solid Waste Incineration in China

Proceedings of International Thermal Treatment Technologies ( IT 3 ) , San Antonio , TX , October 2013 A Rapidly Emerging WTE Technology : Circulating Fluid Bed Combustion

Study On Sewage Sludge Fluidized Bed Incineration And Design Of 65t/D Incinerator

Municipal Solid Waste Fueled Power Generation in China: A Case Study of Waste-To-Energy in Changchun City