Abstract:The cycle frosting and defrosting performance of two types of microchannel heat exchangers were investigated. All the processes were observed using a CCD camera to better understand the cycle frost mechanism. Ice blockage formed in the fin root gaps of the horizontal-tube sample because of water retention. Cycle operation increased the blockage severity until the fin space was completely blocked. The amount of water retained and its impact on frosting time, pressure drop, and capacity were investigated. With increasing water retention, frosting time decreased, air pressure-drop and capacity could not return to the initial value after each defrosting time. Approximately 800. g of water was retained on the heat exchanger after four operating cycles, causing the ice blockage that shortened the effective operating time by 40. min compared with that of the vertical-tube sample at the end of the test. At the beginning of the fifth frost cycle, air pressure-drop had reached thrice the initial pressure drop, even when no frost was on the surface. The capacity decreased by 27% compared with the initial value. However, the vertical-tube sample exhibited no obvious water retention on the surface; as such, pressure drop and capacity experienced a similar degradation process during each cycle. The distribution of ice crystals on the fin surface was also studied, and the frosting process was divided into three periods: initial, developing, and fully grown. With increasingly serious water retention, frost only formed at the fin front-end surface, and could only reach the initial period because the ice blockage rapidly increased the pressure drop, thereby causing the defrosting process. © 2012 Elsevier Ltd.

Experimental Study on Frosting Control of Mobile Air Conditioning System with Microchannel Evaporator

Experimental investigation on frosting performance of a microchannel heat exchanger in heat pump system for electric vehicles

Numerical Analysis of Evaporator Frosting in Automotive Air-Conditioning System with A Variable-Displacement Compressor

Experimental Investigation on the Dynamic Performance of Finned-tube Evaporator in the Frosting Process

An experimental investigation on the frosting and defrosting process of an outdoor heat exchanger in an air conditioning heat pump system for electric vehicles

Principle and Performance Optimization Analysis of a Frost-Free Control for Electric Vehicle Heat Pumps

Simulation and Experimental Study on Finned-Tube Evaporators in the Frosting Process

Research of anti-frosting technology in refrigeration and air conditioning fields: A review

Research Progress of Frost Formation on Microchannel Heat Exchangers

Retarding Frosting of an Air Source Heat Pump by Using Vapor-Bypassed Evaporation Technique

Effect of Different Parameters on Frosting of Evaporator in Frost-free Refrigerator

Experimental Research on Frost Performance of MicroChannel Heat Exchanger

Experimental Investigation of the Performance of Microchannel Heat Exchangers with a New Type of Fin under Wet and Frosting Conditions

Experimental study on the frosting and heat transfer characteristics of cooling surfaces in confined parallel and counter flow channels

Experimental study on frost layer's thermal conductivity of cryogenic vertical plate under natural convection condition

Review on Anti-Frost Technology Based on Microchannel Heat Exchanger

Research on cold storage evaporator applied in automobile A/C system

Experimental investigation of frost and defrost performance of microchannel heat exchangers for heat pump systems

Frost-Air Interface Characterization Under Natural Convection

Numerical analysis and experiment of frosting quality of finned-tube evaporators in low temperature condition

Performance Improvement of Microchannel Heat Exchangers with Modified Louver Fins under Frosting Conditions