Abstract:Measuring mill‐scale thickness in a nondestructive and noncontact fashion in a production environment remains a challenge, as knowledge of the thickness is central to subsequenct processing of the steel strip, such as pickling. Terahertz time‐of‐flight tomography is demonstrated here to enable such nondestructive and noncontact measurement of tertiary mill‐scale thickness down to ~ 10 μm on production hot‐rolled steel, building on our recent work in Ref. [1] on thickness evaluation of laboratory‐produced scale on steel coupons. X‐ray diffraction (XRD) results show that the compositions of the mill‐scale films manufactured under production conditions are slightly different from the laboratory‐prepared steel coupons, resulting from the different compositions of phases present in the two types of samples. The mill‐scale thickness is obtained after advanced signal processing of the raw data, and shows good agreement with values obtained from destructive measurements. Compared to conventional techniques, such as scanning electron microscopy which is destructive, eddy current testing based on electromagnetic induction, which requires direct contact with the surface of samples investigated and is not suitable for large areas, or elevated temperatures, and acoustic inspection, whose spatial resolution is largely limited by its relatively long wavelength, terahertz time‐of‐flight tomography may be implemented for in‐line nondestructive thickness characterization and quality control of optically thin tertiary mill‐scale on steel products, even in a production environment. This article is protected by copyright. All rights reserved.

Research on Reconstruction Algorithm for Instantaneous Steel Strip Profile Gauge

Research on Computation for Cross Section's Edge Positions in X-ray Instantaneous Profile Gauge for Steel Strip

Research on Reconstruction Error Affected by Mechanical Accuracy of X-ray Instantaneous Profile Gauge for Steel Strip

Research on Mechanical Parameters for X-ray Instantaneous Profile Gauge for Hot Steel Strip

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

Theory Analysis and Simulation of Thickness Series for Reference Samples Used in Calibration of X-ray Instantaneous Profile Gauge for Steel Strip

Analysis of Thickness Measure Precision in X-ray Profile Gauge

Experimental Verification of Validity of Parameters of X-ray Module for Profile Gauge

Measurement of deformed surface and key data processing based on reverse engineering

Effects of X-ray Tube Parameters on Thickness Measure Precision in X-ray Profile Gauge

3D Reconstruction of Small-diameter Pipes Inner Surface Based on Structural Light

Scattering Correction of X-ray Thickness Gauge

Research on Binary CT Image Reconstruction of Steel Tube Section from Three Projections

Data Exchange Client Development Based on OPC in Instantaneous Profile Gauge

An On-Line Measurement Method of the Medium Thickness Steel Plate Based on Structured Light Vision Sensor

Application of Image Processing on the On-Line Measurement of Dimensions in the Section of the Hot-Rolled Section Steel

Nondestructive tertiary mill‐scale thickness measurement on commercial hot‐rolled steel strip: terahertz time‐of‐flight tomography

Study on the on-line measurement system for the section dimensions of hot-rolled shaped steel

A Structured Light Vision Sensor for Online Measurement of Steel-Plate Width

The Research on a Physical Model and an Analytical Method of Scatter Signal in X-ray Profile Gauge

Segmentation of Weld Defects in X-ray Image Based on Partial Surface Reconstruction