Abstract:Fluorapatite/hydroxyapatite [Ca 10 (PO 4) 6(OH) 2-x F x, FHA] has similar bioactivity to hydroxyapatite with smaller solubility in human body. FHA films are suitable to be used as coat layer on metallic implants to create bioactivity. In this work, FHA films on Ti6Al4V substrates were prepared by sol-gel technique in Ca(NO 3) 2-P 2O 5-HPF 6-ethanol system. The liquid film was formed by a dip-coating; the as-dipped film was dried at 150℃ for 15 min and heated at 600℃ for 15 min for each run. For each film sample, the dip-coating procedure was repeated for 5 times. The prepared films were characterized by XRD and XPS for identifying the film phase composition and by a soaking test in citric acid modified phosphate buffer solution for measuring film dissolution. The results showed that HPF 6 was a good reagent for the incorporation of fluorine into apatite to form FHA films; the fluorine contents in the film could be controlled; the dissolution of the films decreased with an increase in fluorine content of the films and pH value of the soaking solution. The sol-gel derived FHA films showed a smaller difference in dissolution amount at pH～7, and a large difference at pH～6, compared with the hydroxyapatie film. This behavior demonstrates that the FHA films have good bioactivity besides good stability in body fluid. On the other hand, the FHA films had higher adhesion strength than hydroxyapatite film. This could be attributed to the smaller thermal expansion coefficient of FHA which leads to smaller thermal residues stress.

Phase Structure and Thermal Stability of Prepared FHA Powders

Crystallization Characteristics and Thermal Stability of Fluor-Hydroxyapatite Composites with Zirconia

Sol-gel Preparation of Fluoridated Hydroxyapatite in Ca(NO3)2-PO(OH)3−x(OEt)x-HPF6 System

Synthesis and Characterization of Fluoridated Hydroxyapatite with a Novel Fluorine-Containing Reagent

Preparation and thermal stability analysis of hydroxyapatite derived from the precipitation process and microwave irradiation method

Phase Transition During Sintering Process Before Nucleation of TFA-MOD YBa2Cu3O7-δ Films

Doping Effects In (Ba0.85ca0.15)(Hf0.1ti0.9)O-3 Lead-Free Piezoelectric Ceramics Prepared Via Powder Injection Moulding Using Simple Binder

Influence of Temperature, Pressure and Humidity on the Stabilities and Transitions Kinetics of the Various Polymorphs of FAPbI$_3$

The F content in sol–gel derived FHA coatings: an XPS study

The Interfacial Study of Sol–gel-Derived Fluoridated Hydroxyapatite Coatings

Coatings of needle/stripe-like fluoridated hydroxyapatite on H2O2-treated carbon/carbon composites prepared by induction heating and hydrothermal methods

Phase transformation and thermal conductivity of the APS Y2O3 doped HfO2 coating with hybrid structure

Structural Evolution and Mechanical Behavior of Ytterbia Doped Hafnia Biphasic Ceramics under Annealing at 1500 °C

Stability of CaF2 at High Temperature

Phase Transition During Heat Treatment of Precursor Before YBa 2 Cu 3 O 7− Δ Nucleation in TFA–MOD Method

Fluoridation of Synthetic Apatite: Effect on the Formation of Calcium-Deficient Hydroxyapatite and the Properties of Porous Scaffold

Phase Formation and Thermal Stability of fcc (Fluorite) Ce1−xTbxO2−δ Solid Solutions

Sol-gel Derived Fluorapatite/Hydroxyapatite Films and Their Solubility

Microstructures and phase compositions of Y2O3–ZrO2–HfO2 solid solutions

Characterization, mechanical properties, corrosion behaviour and bone-like apatite formation ability of fluorine substituted hydroxyapatite coating

Effect of CaF2 on the Electrical Properties of Yttria-Stabilized Zirconia