Abstract:PurposeThe micro-vibrations of some flexible appendages onboard satellite such as reaction wheels, scanning mechanisms etc, will severely influenced the optical precision of the imager. To guarantee the imager orientation accuracy of high resolution satellite, this study focused on designing an isolation system to attenuate the influences of on orbit micro-vibration.MethodsStwart configuration is employed to construct the reaction wheel isolation system which contains six single isolators. A launch environment damper is designed to guarantee the structure safety of isolators without lock mechanisms at launching term which simplify the whole isolation system. The imager isolation system is composed of three special springs which are placed between imager basement and roof board of the satellite to isolate the disturbances to the imager. Both isolation systems are compose together for the satellite to attenuate the influences of on orbit micro-vibration.ResultsExperiments are designed to validate the productivity of the micro-vibration isolation system both in component and satellite level. The sine vibration experiment results show that the maximal acceleration output 34.61g is much lower than the flywheel design value 49g which guarantees the safety of flywheel under harsh launch environment. The experiment results in satellite level show that the vibration output in three directions changes smoothly and the imager orientation accuracy is 10.89urad (3σdocumentclass[12pt]{minimal}usepackage{amsmath}usepackage{wasysym}usepackage{amsfonts}usepackage{amssymb}usepackage{amsbsy}usepackage{mathrsfs}usepackage{upgreek}setlength{oddsidemargin}{-69pt}egin{document}$$3sigma$$end{document}) which is suitable for the requirement of the imager onboard the SDLT-1 satellite.ConclusionThe proposed method has been applied to the SDLT-1 satellite and the experiment results in component and satellite level show the feasibility of the method. Some satellite with rigorous micro-vibration requirement could employ the proposed method of this study.

High Frequency Vibration Isolation of CMG for Satellite

Experimental modeling and optimization of single-gimbal CMG vibration isolator

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Simulation And Design Of Composite Vibration Isolator For Spacecrafts

Benefit of Relaxation-Type Damping on the Performance of a Six-Degree-of-Freedom Microvibration Isolation Device for Control Moment Gyroscope

Experiment on Active Vibration Isolation of a Conical Shell Isolator

Research on Passive Isolation Characteristics and Rocket-spacecraft Coupling of a New Whole-spacecraft Isolation Platform

Study on Micro-vibration Isolation System Design and Validation for the SDLT-1 Satellite of China

Dynamic modeling and open-loop analysis of a control moment gyroscope considering the influence of a flexible vibration isolator

CMG isolator design with consideration of singularity problem

Analysis for the Principle of Whole-Spacecraft Vibration Isolation

Study of Whole-Satellite Active Vibration Isolation Platform

Singularity Problem of Control Moment Gyro Cluster with Vibration Isolators

Multi-direction vibration isolator for momentum wheel assemblies

The coupling analysis for the gimbal servo system of a control moment gyroscope considering the influence of a flexible vibration isolator

Design of active vibration isolation system for satellite optical load based on Stewart platform

Design and experiment of dual micro-vibration isolation system for optical satellite flywheel

Modeling and Analysis of Bio-Inspired, Reconfigurable, Piezo-Driven Vibration Isolator for Spacecraft

Design of a Maglev Stewart Platform for the Microgravity Vibration Isolation

Study on the Micro-vibration Suppression of a MnCu Spring Isolation Platform with Low Stiffness and High Damping

Active Vibration Suppression of Payloads with a Conical Isolator