Abstract:We proposed a novel method of fabricating polydimethylsiloxane (PDMS) microfluidic chip polymer master molds in this paper. The method mainly includes two steps. First, a stainless steel slice was laser etched to form a metal model. Then, the organic solution of poly(methyl methacrylate) (PMMA) was casted onto the metal model to fabricate the PMMA master which subsequently would be used to fabricate PDMS chips. We systematically researched different laser parameters influencing the surface status of microchannels and obtained optimized etching parameters. We investigated and optimized the organic solution composition of PMMA while casting chip masters, and developed a method to form fine polymer masters using two different viscosity solutions to cast the model in turn, and studied the repeatable replication. Then, we investigated physical performance of this chip and evaluated the practicability by analyzing Rhodamine B. Compared with present methods, the proposed method does not need photolithography on photoresistant and chemical etching. The entire fabricating progress is simple, fast, low-cost and can be controlled easily. Only several minutes are required to make a metal model, 3 hours for a PMMA master, and one day for PDMS chips.

Preparation Of Micro Fluidic Chip Based On Su-8 Mold

Microfluidic Mold Insert Prepared Using a Novel Method

PDMS Molding Technology Using in Extract Typical Characteristic in Microfluidic-Chip

Micro Hot Embossing Metal Mold For Microfluidic Chip Based On No Back Plate Growing Method

A Low-Cost Method of Fabricating Hybrid Micro-Nano Fluidic Chip by Double-Layer PDMS Mold and UV–thermal Nanoimprinting

A Simplified Microfabrication Technology for Production of Nickel Mold Insert for Replicating of Plastic Microfluidic Chips

Micro-molding for poly(dimethylsiloxane) microchips

Swelling of SU-8 Structure in Ni Mold Fabrication by UV-LIGA Technique

Route to one-step microstructure mold fabrication for PDMS microfluidic chip

Novel polydimethylsiloxane (PDMS) based microchannel fabrication method for lab-on-a-chip application

Fabrication of Su-8 Moulds on Glass Substrates by Using A Common Thin Negative Photoresist As an Adhesive Layer

Fabrication of a Three-Layer SU-8 Mould with Inverted T-shaped Cavities Based on a Sacrificial Photoresist Layer Technique

Fabrication Of Microfluidic Chip And Its Application

A novel method for fabricating polydimethylsiloxane microfluidic chip master molds

Fabrication of CE Microchip Based on SU8 and PMMA

Design and Fabrication of Micro Hot Embossing Mold for Microfluidic Chip Used in Flow Cytometry

Research on Micro Fluidic Chips Used for Bioluminescence Detection

Novel Fabrication Technology Of Polydimethylsiloxane Microfluidic Chip

A New Silicon Mold Process for Polydimethylsiloxane Microchannels

Non-planar Electroforming of Microfluidic Mold Insert

Fast fabrication of PDMS microfluidic electrophoresis chip