Organic–inorganic nanocomposite films made from polyurethane dispersions and colloidal silica particles
Magdalena Serkis,Milena Špírková,Jana Kredatusová,Jiří Hodan,Radovan Bureš
DOI: https://doi.org/10.1080/09276440.2016.1124666
IF: 2.839
2016-01-11
Composite Interfaces
Abstract:Polyurethane/silica nanocomposites were prepared by solution blending of polyurethane water dispersion (PUD) based on polycarbonate macrodiol with colloidal silica aqueous sol LUDOX TMA. Because of mixing PUDs made from linear polyurethane with the nanofiller, only physical polymer/filler type of interface formed by hydrogen bonds was obtained. As a result the materials were possible to reuse after dissolution in acetone followed by dispersion in water. The effect of colloidal silica content on mechanical, thermal, morphological, and swelling properties of obtained films was tested by tensile test, dynamic mechanical thermal analysis, thermogravimertic analysis, scanning electron microscopy, atomic force microscopy, and swelling analyses. The nanocomposites were classified in three groups differing in the internal structure and functional properties: organic matrix filled with inorganic nanofiller (up to 10 wt% of silica), bicontinous systems (25 and 32 wt% of silica) and inorganic matrix filled with polyurethane (50 and 60 wt% of silica). Only small amount of colloidal silica (up to 10 wt%) improves thermo-mechanical properties, smoothes the materials, and suppresses extent of swelling without changing of the films transparency.
materials science, composites