Abstract:During the operation progress of solid oxide fuel cell (SOFC), the performance and endurance are two major concerns significantly affected by gas flowing, charge transport, and chemical reaction. This paper presents a thorough research on the key parameters related to syngas and charge transport in the SOFC to reveal the intrinsic influence mechanism, including electro conductibility, gas mixture concentration, CH 4 component ratio, temperature, and anode thickness, which is instrumental in improving the operational efficiency and applicability of SOFC. Firstly, the theoretical models of charge transport and multi-component mass transfer are established, respectively, and the two are coupled using the reaction rate calculation method. Then, employing an innovative combination of the representative elementary volume (REV) scale lattice Boltzmann method (LBM) and the finite-difference LBM, the potential and multi-component gases distributions are simulated to calculate the evaluated indicators, namely activation and concentration overpotential. Finally, considering various operational conditions, the simulation experiments are conducted to investigate the parametric effect on the performance of SOFC fueled by syngas. The results demonstrate that compared to the direct reforming way, the external syngas with lower CH 4 component ratio is more favorable to the SOFC and the optimal ratio should be controlled within 0.2. The higher concentration of gas mixture and lower anode thickness both contribute to weakening the effect of concentration polarization. Especially, the performance of SOFC is improved when the concentration is 15 mol‧m −3 and the anode thickness is below 1.05 mm. With the increment of conductivity and operating temperature, the consumption of H 2 gradually increases, enhancing the efficiency of reaction gas and reducing the economic cost. And the optimal operation temperature of SOFC is about 1073 K. Moreover, the anode thickness is a trade-off between the electrochemical reaction conditions of anode and cathode, as its variation affects both of them.

Effects of Syngas Components on the Carbon Formation in Planar Solid Oxide Fuel Cell

Numerical Analysis of the Possibility of Carbon Formation in Planar SOFC Fueled with Syngas

Effects of Coal Syngas Major Compositions on Ni/Ysz Anode-Supported Solid Oxide Fuel Cells

Numerical simulation of carbon deposition in solid oxide fuel cells

Elementary Reaction Kinetic Model of an Anode-Supported Syngas Fueled Solid Oxide Fuel Cell Considering the Carbon Deposition Effect

Parametric analysis of solid oxide fuel cell fueled by syngas based on lattice Boltzmann method

Numerical investigation of different loads effect on the performance of planar electrode supported SOFC with syngas as fuel

Elementary reaction kinetic model of an anode-supported solid oxide fuel cell fueled with syngas

Effect of syngas flow rate on the performance of solid oxide fuel cell

Syngas Production Via Coal Char-Co 2 Fluidized Bed Gasification and the Effect on the Performance of LSCFN//LSGM//LSCFN Solid Oxide Fuel Cell

Performance of Planar Electrode Supported Solid Oxide Fuel Cell With Syngas as Fuel

Performance and Effective Kinetic Models of Methane Steam Reforming over an Ni-YSZ Anode of Planar Solid Oxide Fuel Cell

Investigation of Carbon Formation on Ni/YSZ Anode of Solid Oxide Fuel Cell from CO Disproportionation Reaction

Degradation mechanisms and mitigation strategies of direct methane solid oxide fuel cells

Controlled Deposition and Utilization of Carbon on Ni-Ysz Anodes of Sofcs Operating on Dry Methane

Investigation into the Effects of Sulfur on Syngas Reforming Inside a Solid Oxide Fuel Cell

Evaluation of Carbon Deposition Behavior on the Nickel/yttrium-Stabilized Zirconia Anode-Supported Fuel Cell Fueled with Simulated Syngas

Numerical Simulation of Fluidized Bed Gasifier Coupled with Solid Oxide Fuel Cell Fed with Solid Carbon

Solid Oxide Fuel Cells Fueled by Simulated Biogas: Comparison of Anode Modification by Infiltration and Reforming Catalytic Layer

Numerical investigation of the chemical and electrochemical characteristics of planar solid oxide fuel cell with direct internal reforming

Experimental Study of the Carbon Deposition from CH4 Onto the Ni/YSZ Anode of SOFCs